1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
|
From 0000000000000000000000000000000000000000 Mon Sep 17 00:00:00 2001
From: Benjamin Marzinski <bmarzins@redhat.com>
Date: Wed, 31 May 2017 15:03:02 -0500
Subject: [PATCH] multipath: set verbosity to default during config
condlog was setting the verbosity to 0 if there was no configuration.
This keeps multipath from printing warning messages about config file
problems that are found while loading the configuration. Instead, it
should use the default config level until it loads the configuration
to find the current value.
Signed-off-by: Benjamin Marzinski <bmarzins@redhat.com>
---
libmultipath/debug.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/libmultipath/debug.c b/libmultipath/debug.c
index fbe171a..f89b264 100644
--- a/libmultipath/debug.c
+++ b/libmultipath/debug.c
@@ -11,6 +11,7 @@
#include "../third-party/valgrind/drd.h"
#include "vector.h"
#include "config.h"
+#include "defaults.h"
void dlog (int sink, int prio, const char * fmt, ...)
{
@@ -21,7 +22,7 @@ void dlog (int sink, int prio, const char * fmt, ...)
va_start(ap, fmt);
conf = get_multipath_config();
ANNOTATE_IGNORE_READS_BEGIN();
- thres = (conf) ? conf->verbosity : 0;
+ thres = (conf) ? conf->verbosity : DEFAULT_VERBOSITY;
ANNOTATE_IGNORE_READS_END();
put_multipath_config(conf);
--
2.7.4
|
