1 files changed, 80 insertions, 10 deletions

diff --git a/arch/blackfin/mach-bf527/boards/ezbrd.c b/arch/blackfin/mach-bf527/boards/ezbrd.c
index 36c87b6fbde..0314bd3355e 100644
--- a/arch/blackfin/mach-bf527/boards/ezbrd.c
+++ b/arch/blackfin/mach-bf527/boards/ezbrd.c
@@ -51,7 +51,7 @@
 /*
  * Name the Board for the /proc/cpuinfo
  */
-const char bfin_board_name[] = "BF526-EZBRD";
+const char bfin_board_name[] = "ADI BF526-EZBRD";
 
 /*
  *  Driver needs to know address, irq and flag pin.
@@ -81,8 +81,8 @@ static struct musb_hdrc_config musb_config = {
 	.dyn_fifo	= 0,
 	.soft_con	= 1,
 	.dma		= 1,
-	.num_eps	= 7,
-	.dma_channels	= 7,
+	.num_eps	= 8,
+	.dma_channels	= 8,
 	.gpio_vrsel	= GPIO_PG13,
 };
 
@@ -288,6 +288,30 @@ static const struct ad7877_platform_data bfin_ad7877_ts_info = {
 };
 #endif
 
+#if defined(CONFIG_TOUCHSCREEN_AD7879) || defined(CONFIG_TOUCHSCREEN_AD7879_MODULE)
+#include <linux/spi/ad7879.h>
+static const struct ad7879_platform_data bfin_ad7879_ts_info = {
+	.model			= 7879,	/* Model = AD7879 */
+	.x_plate_ohms		= 620,	/* 620 Ohm from the touch datasheet */
+	.pressure_max		= 10000,
+	.pressure_min		= 0,
+	.first_conversion_delay = 3,	/* wait 512us before do a first conversion */
+	.acquisition_time 	= 1,	/* 4us acquisition time per sample */
+	.median			= 2,	/* do 8 measurements */
+	.averaging 		= 1,	/* take the average of 4 middle samples */
+	.pen_down_acc_interval 	= 255,	/* 9.4 ms */
+	.gpio_output		= 1,	/* configure AUX/VBAT/GPIO as GPIO output */
+	.gpio_default 		= 1,	/* During initialization set GPIO = HIGH */
+};
+#endif
+
+#if defined(CONFIG_TOUCHSCREEN_AD7879_SPI) || defined(CONFIG_TOUCHSCREEN_AD7879_SPI_MODULE)
+static struct bfin5xx_spi_chip spi_ad7879_chip_info = {
+	.enable_dma = 0,
+	.bits_per_word = 16,
+};
+#endif
+
 #if defined(CONFIG_SND_SOC_WM8731) || defined(CONFIG_SND_SOC_WM8731_MODULE) \
 	 && defined(CONFIG_SND_SOC_WM8731_SPI)
 static struct bfin5xx_spi_chip spi_wm8731_chip_info = {
@@ -386,6 +410,18 @@ static struct spi_board_info bfin_spi_board_info[] __initdata = {
 		.controller_data = &spi_ad7877_chip_info,
 	},
 #endif
+#if defined(CONFIG_TOUCHSCREEN_AD7879_SPI) || defined(CONFIG_TOUCHSCREEN_AD7879_SPI_MODULE)
+	{
+		.modalias = "ad7879",
+		.platform_data = &bfin_ad7879_ts_info,
+		.irq = IRQ_PG0,
+		.max_speed_hz = 5000000,     /* max spi clock (SCK) speed in HZ */
+		.bus_num = 0,
+		.chip_select = 5,
+		.controller_data = &spi_ad7879_chip_info,
+		.mode = SPI_CPHA | SPI_CPOL,
+	},
+#endif
 #if defined(CONFIG_SND_SOC_WM8731) || defined(CONFIG_SND_SOC_WM8731_MODULE) \
 	 && defined(CONFIG_SND_SOC_WM8731_SPI)
 	{
@@ -478,30 +514,59 @@ static struct platform_device bfin_uart_device = {
 #endif
 
 #if defined(CONFIG_BFIN_SIR) || defined(CONFIG_BFIN_SIR_MODULE)
-static struct resource bfin_sir_resources[] = {
 #ifdef CONFIG_BFIN_SIR0
+static struct resource bfin_sir0_resources[] = {
 	{
 		.start = 0xFFC00400,
 		.end = 0xFFC004FF,
 		.flags = IORESOURCE_MEM,
 	},
+	{
+		.start = IRQ_UART0_RX,
+		.end = IRQ_UART0_RX+1,
+		.flags = IORESOURCE_IRQ,
+	},
+	{
+		.start = CH_UART0_RX,
+		.end = CH_UART0_RX+1,
+		.flags = IORESOURCE_DMA,
+	},
+};
+
+static struct platform_device bfin_sir0_device = {
+	.name = "bfin_sir",
+	.id = 0,
+	.num_resources = ARRAY_SIZE(bfin_sir0_resources),
+	.resource = bfin_sir0_resources,
+};
 #endif
 #ifdef CONFIG_BFIN_SIR1
+static struct resource bfin_sir1_resources[] = {
 	{
 		.start = 0xFFC02000,
 		.end = 0xFFC020FF,
 		.flags = IORESOURCE_MEM,
 	},
-#endif
+	{
+		.start = IRQ_UART1_RX,
+		.end = IRQ_UART1_RX+1,
+		.flags = IORESOURCE_IRQ,
+	},
+	{
+		.start = CH_UART1_RX,
+		.end = CH_UART1_RX+1,
+		.flags = IORESOURCE_DMA,
+	},
 };
 
-static struct platform_device bfin_sir_device = {
+static struct platform_device bfin_sir1_device = {
 	.name = "bfin_sir",
-	.id = 0,
-	.num_resources = ARRAY_SIZE(bfin_sir_resources),
-	.resource = bfin_sir_resources,
+	.id = 1,
+	.num_resources = ARRAY_SIZE(bfin_sir1_resources),
+	.resource = bfin_sir1_resources,
 };
 #endif
+#endif
 
 #if defined(CONFIG_I2C_BLACKFIN_TWI) || defined(CONFIG_I2C_BLACKFIN_TWI_MODULE)
 static struct resource bfin_twi0_resource[] = {
@@ -671,7 +736,12 @@ static struct platform_device *stamp_devices[] __initdata = {
 #endif
 
 #if defined(CONFIG_BFIN_SIR) || defined(CONFIG_BFIN_SIR_MODULE)
-	&bfin_sir_device,
+#ifdef CONFIG_BFIN_SIR0
+	&bfin_sir0_device,
+#endif
+#ifdef CONFIG_BFIN_SIR1
+	&bfin_sir1_device,
+#endif
 #endif
 
 #if defined(CONFIG_I2C_BLACKFIN_TWI) || defined(CONFIG_I2C_BLACKFIN_TWI_MODULE)