summaryrefslogtreecommitdiffstats
path: root/Documentation/video4linux/v4l2-framework.txt
diff options
context:
space:
mode:
Diffstat (limited to 'Documentation/video4linux/v4l2-framework.txt')
-rw-r--r--Documentation/video4linux/v4l2-framework.txt16
1 files changed, 6 insertions, 10 deletions
diff --git a/Documentation/video4linux/v4l2-framework.txt b/Documentation/video4linux/v4l2-framework.txt
index ba4706afc5f..e395a9cdc53 100644
--- a/Documentation/video4linux/v4l2-framework.txt
+++ b/Documentation/video4linux/v4l2-framework.txt
@@ -370,19 +370,20 @@ from the remove() callback ensures that this is always done correctly.
The bridge driver also has some helper functions it can use:
struct v4l2_subdev *sd = v4l2_i2c_new_subdev(v4l2_dev, adapter,
- "module_foo", "chipid", 0x36);
+ "module_foo", "chipid", 0x36, NULL);
This loads the given module (can be NULL if no module needs to be loaded) and
calls i2c_new_device() with the given i2c_adapter and chip/address arguments.
If all goes well, then it registers the subdev with the v4l2_device.
-You can also use v4l2_i2c_new_probed_subdev() which is very similar to
-v4l2_i2c_new_subdev(), except that it has an array of possible I2C addresses
-that it should probe. Internally it calls i2c_new_probed_device().
+You can also use the last argument of v4l2_i2c_new_subdev() to pass an array
+of possible I2C addresses that it should probe. These probe addresses are
+only used if the previous argument is 0. A non-zero argument means that you
+know the exact i2c address so in that case no probing will take place.
Both functions return NULL if something went wrong.
-Note that the chipid you pass to v4l2_i2c_new_(probed_)subdev() is usually
+Note that the chipid you pass to v4l2_i2c_new_subdev() is usually
the same as the module name. It allows you to specify a chip variant, e.g.
"saa7114" or "saa7115". In general though the i2c driver autodetects this.
The use of chipid is something that needs to be looked at more closely at a
@@ -410,11 +411,6 @@ the irq and platform_data arguments after the subdev was setup. The older
v4l2_i2c_new_(probed_)subdev functions will call s_config as well, but with
irq set to 0 and platform_data set to NULL.
-Note that in the next kernel release the functions v4l2_i2c_new_subdev,
-v4l2_i2c_new_probed_subdev and v4l2_i2c_new_probed_subdev_addr will all be
-replaced by a single v4l2_i2c_new_subdev that is identical to
-v4l2_i2c_new_subdev_cfg but without the irq and platform_data arguments.
-
struct video_device
-------------------