1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
262
263
264
265
266
267
268
269
|
// SPDX-License-Identifier: GPL-2.0+
/*
* (C) Copyright 2016 Beniamino Galvani <b.galvani@gmail.com>
* (C) Copyright 2018 Neil Armstrong <narmstrong@baylibre.com>
*/
#include <common.h>
#include <init.h>
#include <asm/arch/boot.h>
#include <asm/arch/eth.h>
#include <asm/arch/gx.h>
#include <asm/arch/mem.h>
#include <asm/arch/meson-vpu.h>
#include <asm/io.h>
#include <asm/armv8/mmu.h>
#include <linux/sizes.h>
#include <usb.h>
#include <linux/usb/otg.h>
#include <asm/arch/usb-gx.h>
#include <usb/dwc2_udc.h>
#include <clk.h>
#include <phy.h>
DECLARE_GLOBAL_DATA_PTR;
int meson_get_boot_device(void)
{
return readl(GX_AO_SEC_GP_CFG0) & GX_AO_BOOT_DEVICE;
}
/* Configure the reserved memory zones exported by the secure registers
* into EFI and DTB reserved memory entries.
*/
void meson_init_reserved_memory(void *fdt)
{
u64 bl31_size, bl31_start;
u64 bl32_size, bl32_start;
u32 reg;
/*
* Get ARM Trusted Firmware reserved memory zones in :
* - AO_SEC_GP_CFG3: bl32 & bl31 size in KiB, can be 0
* - AO_SEC_GP_CFG5: bl31 physical start address, can be NULL
* - AO_SEC_GP_CFG4: bl32 physical start address, can be NULL
*/
reg = readl(GX_AO_SEC_GP_CFG3);
bl31_size = ((reg & GX_AO_BL31_RSVMEM_SIZE_MASK)
>> GX_AO_BL31_RSVMEM_SIZE_SHIFT) * SZ_1K;
bl32_size = (reg & GX_AO_BL32_RSVMEM_SIZE_MASK) * SZ_1K;
bl31_start = readl(GX_AO_SEC_GP_CFG5);
bl32_start = readl(GX_AO_SEC_GP_CFG4);
/*
* Early Meson GX Firmware revisions did not provide the reserved
* memory zones in the registers, keep fixed memory zone handling.
*/
if (IS_ENABLED(CONFIG_MESON_GX) &&
!reg && !bl31_start && !bl32_start) {
bl31_start = 0x10000000;
bl31_size = 0x200000;
}
/* Add first 16MiB reserved zone */
meson_board_add_reserved_memory(fdt, 0, GX_FIRMWARE_MEM_SIZE);
/* Add BL31 reserved zone */
if (bl31_start && bl31_size)
meson_board_add_reserved_memory(fdt, bl31_start, bl31_size);
/* Add BL32 reserved zone */
if (bl32_start && bl32_size)
meson_board_add_reserved_memory(fdt, bl32_start, bl32_size);
#if defined(CONFIG_VIDEO_MESON)
meson_vpu_rsv_fb(fdt);
#endif
}
phys_size_t get_effective_memsize(void)
{
/* Size is reported in MiB, convert it in bytes */
return ((readl(GX_AO_SEC_GP_CFG0) & GX_AO_MEM_SIZE_MASK)
>> GX_AO_MEM_SIZE_SHIFT) * SZ_1M;
}
static struct mm_region gx_mem_map[] = {
{
.virt = 0x0UL,
.phys = 0x0UL,
.size = 0xc0000000UL,
.attrs = PTE_BLOCK_MEMTYPE(MT_NORMAL) |
PTE_BLOCK_INNER_SHARE
}, {
.virt = 0xc0000000UL,
.phys = 0xc0000000UL,
.size = 0x30000000UL,
.attrs = PTE_BLOCK_MEMTYPE(MT_DEVICE_NGNRNE) |
PTE_BLOCK_NON_SHARE |
PTE_BLOCK_PXN | PTE_BLOCK_UXN
}, {
/* List terminator */
0,
}
};
struct mm_region *mem_map = gx_mem_map;
/* Configure the Ethernet MAC with the requested interface mode
* with some optional flags.
*/
void meson_eth_init(phy_interface_t mode, unsigned int flags)
{
switch (mode) {
case PHY_INTERFACE_MODE_RGMII:
case PHY_INTERFACE_MODE_RGMII_ID:
case PHY_INTERFACE_MODE_RGMII_RXID:
case PHY_INTERFACE_MODE_RGMII_TXID:
/* Set RGMII mode */
setbits_le32(GX_ETH_REG_0, GX_ETH_REG_0_PHY_INTF |
GX_ETH_REG_0_TX_PHASE(1) |
GX_ETH_REG_0_TX_RATIO(4) |
GX_ETH_REG_0_PHY_CLK_EN |
GX_ETH_REG_0_CLK_EN);
/* Reset to external PHY */
if(!IS_ENABLED(CONFIG_MESON_GXBB))
writel(0x2009087f, GX_ETH_REG_3);
break;
case PHY_INTERFACE_MODE_RMII:
/* Set RMII mode */
out_le32(GX_ETH_REG_0, GX_ETH_REG_0_INVERT_RMII_CLK |
GX_ETH_REG_0_CLK_EN);
/* Use GXL RMII Internal PHY (also on GXM) */
if (!IS_ENABLED(CONFIG_MESON_GXBB)) {
if ((flags & MESON_USE_INTERNAL_RMII_PHY)) {
writel(0x10110181, GX_ETH_REG_2);
writel(0xe40908ff, GX_ETH_REG_3);
} else
writel(0x2009087f, GX_ETH_REG_3);
}
break;
default:
printf("Invalid Ethernet interface mode\n");
return;
}
/* Enable power gate */
clrbits_le32(GX_MEM_PD_REG_0, GX_MEM_PD_REG_0_ETH_MASK);
}
#if CONFIG_IS_ENABLED(USB_XHCI_DWC3_OF_SIMPLE) && \
CONFIG_IS_ENABLED(USB_GADGET_DWC2_OTG)
static struct dwc2_plat_otg_data meson_gx_dwc2_data;
static struct phy usb_phys[2];
int board_usb_init(int index, enum usb_init_type init)
{
struct ofnode_phandle_args args;
struct udevice *clk_dev;
ofnode dwc2_node;
struct clk clk;
int ret, i;
u32 val;
/* find the dwc2 node */
dwc2_node = ofnode_by_compatible(ofnode_null(), "snps,dwc2");
if (!ofnode_valid(dwc2_node)) {
debug("Not found dwc2 node\n");
return -ENODEV;
}
if (!ofnode_is_available(dwc2_node)) {
debug("dwc2 is disabled in the device tree\n");
return -ENODEV;
}
/* get the PHYs */
for (i = 0; i < 2; i++) {
ret = generic_phy_get_by_node(dwc2_node, i, &usb_phys[i]);
if (ret && ret != -ENOENT) {
pr_err("Failed to get USB PHY%d for %s\n",
i, ofnode_get_name(dwc2_node));
return ret;
}
}
for (i = 0; i < 2; i++) {
ret = generic_phy_init(&usb_phys[i]);
if (ret) {
pr_err("Can't init USB PHY%d for %s\n",
i, ofnode_get_name(dwc2_node));
return ret;
}
}
for (i = 0; i < 2; i++) {
ret = generic_phy_power_on(&usb_phys[i]);
if (ret) {
pr_err("Can't power USB PHY%d for %s\n",
i, ofnode_get_name(dwc2_node));
return ret;
}
}
phy_meson_gxl_usb3_set_mode(&usb_phys[0], USB_DR_MODE_PERIPHERAL);
phy_meson_gxl_usb2_set_mode(&usb_phys[1], USB_DR_MODE_PERIPHERAL);
meson_gx_dwc2_data.regs_otg = ofnode_get_addr(dwc2_node);
if (meson_gx_dwc2_data.regs_otg == FDT_ADDR_T_NONE) {
debug("usbotg: can't get base address\n");
return -ENODATA;
}
/* Enable clock */
ret = ofnode_parse_phandle_with_args(dwc2_node, "clocks",
"#clock-cells", 0, 0, &args);
if (ret) {
debug("usbotg has no clocks defined in the device tree\n");
return ret;
}
ret = uclass_get_device_by_ofnode(UCLASS_CLK, args.node, &clk_dev);
if (ret)
return ret;
if (args.args_count != 1) {
debug("Can't find clock ID in the device tree\n");
return -ENODATA;
}
clk.dev = clk_dev;
clk.id = args.args[0];
ret = clk_enable(&clk);
if (ret) {
debug("Failed to enable usbotg clock\n");
return ret;
}
ofnode_read_u32(dwc2_node, "g-rx-fifo-size", &val);
meson_gx_dwc2_data.rx_fifo_sz = val;
ofnode_read_u32(dwc2_node, "g-np-tx-fifo-size", &val);
meson_gx_dwc2_data.np_tx_fifo_sz = val;
ofnode_read_u32(dwc2_node, "g-tx-fifo-size", &val);
meson_gx_dwc2_data.tx_fifo_sz = val;
return dwc2_udc_probe(&meson_gx_dwc2_data);
}
int board_usb_cleanup(int index, enum usb_init_type init)
{
int i;
phy_meson_gxl_usb3_set_mode(&usb_phys[0], USB_DR_MODE_HOST);
phy_meson_gxl_usb2_set_mode(&usb_phys[1], USB_DR_MODE_HOST);
for (i = 0; i < 2; i++)
usb_phys[i].dev = NULL;
return 0;
}
#endif
|
