diff options
Diffstat (limited to 'include/linux/mtd/nand.h')
| -rw-r--r-- | include/linux/mtd/nand.h | 65 |
1 files changed, 41 insertions, 24 deletions
diff --git a/include/linux/mtd/nand.h b/include/linux/mtd/nand.h index 34945fda70..b5a02c3382 100644 --- a/include/linux/mtd/nand.h +++ b/include/linux/mtd/nand.h @@ -25,6 +25,8 @@ struct mtd_info; struct nand_flash_dev; +struct device_node; + /* Scan and identify a NAND device */ extern int nand_scan(struct mtd_info *mtd, int max_chips); /* @@ -144,6 +146,14 @@ typedef enum { /* Enable Hardware ECC before syndrome is read back from flash */ #define NAND_ECC_READSYN 2 +/* + * Enable generic NAND 'page erased' check. This check is only done when + * ecc.correct() returns -EBADMSG. + * Set this flag if your implementation does not fix bitflips in erased + * pages and you want to rely on the default implementation. + */ +#define NAND_ECC_GENERIC_ERASED_CHECK BIT(0) + /* Bit mask for flags passed to do_nand_read_ecc */ #define NAND_GET_DEVICE 0x80 @@ -179,6 +189,12 @@ typedef enum { /* Device supports subpage reads */ #define NAND_SUBPAGE_READ 0x00001000 +/* + * Some MLC NANDs need data scrambling to limit bitflips caused by repeated + * patterns. + */ +#define NAND_NEED_SCRAMBLING 0x00002000 + /* Options valid for Samsung large page devices */ #define NAND_SAMSUNG_LP_OPTIONS NAND_CACHEPRG @@ -203,6 +219,11 @@ typedef enum { * before calling nand_scan_tail. */ #define NAND_BUSWIDTH_AUTO 0x00080000 +/* + * This option could be defined by controller drivers to protect against + * kmap'ed, vmalloc'ed highmem buffers being passed from upper layers + */ +#define NAND_USE_BOUNCE_BUFFER 0x00100000 /* Options set by nand scan */ /* bbt has already been read */ @@ -292,15 +313,15 @@ struct nand_onfi_params { __le16 t_r; __le16 t_ccs; __le16 src_sync_timing_mode; - __le16 src_ssync_features; + u8 src_ssync_features; __le16 clk_pin_capacitance_typ; __le16 io_pin_capacitance_typ; __le16 input_pin_capacitance_typ; u8 input_pin_capacitance_max; u8 driver_strength_support; __le16 t_int_r; - __le16 t_ald; - u8 reserved4[7]; + __le16 t_adl; + u8 reserved4[8]; /* vendor */ __le16 vendor_revision; @@ -423,7 +444,7 @@ struct nand_jedec_params { __le16 input_pin_capacitance_typ; __le16 clk_pin_capacitance_typ; u8 driver_strength_support; - __le16 t_ald; + __le16 t_adl; u8 reserved4[36]; /* ECC and endurance block */ @@ -466,12 +487,19 @@ struct nand_hw_control { * @total: total number of ECC bytes per page * @prepad: padding information for syndrome based ECC generators * @postpad: padding information for syndrome based ECC generators + * @options: ECC specific options (see NAND_ECC_XXX flags defined above) * @layout: ECC layout control struct pointer * @priv: pointer to private ECC control data * @hwctl: function to control hardware ECC generator. Must only * be provided if an hardware ECC is available * @calculate: function for ECC calculation or readback from ECC hardware - * @correct: function for ECC correction, matching to ECC generator (sw/hw) + * @correct: function for ECC correction, matching to ECC generator (sw/hw). + * Should return a positive number representing the number of + * corrected bitflips, -EBADMSG if the number of bitflips exceed + * ECC strength, or any other error code if the error is not + * directly related to correction. + * If -EBADMSG is returned the input buffers should be left + * untouched. * @read_page_raw: function to read a raw page without ECC. This function * should hide the specific layout used by the ECC * controller and always return contiguous in-band and @@ -509,6 +537,7 @@ struct nand_ecc_ctrl { int strength; int prepad; int postpad; + unsigned int options; struct nand_ecclayout *layout; void *priv; void (*hwctl)(struct mtd_info *mtd, int mode); @@ -556,6 +585,7 @@ struct nand_buffers { /** * struct nand_chip - NAND Private Flash Chip Data + * @mtd: MTD device registered to the MTD framework * @IO_ADDR_R: [BOARDSPECIFIC] address to read the 8 I/O lines of the * flash device * @IO_ADDR_W: [BOARDSPECIFIC] address to write the 8 I/O lines of the @@ -571,10 +601,6 @@ struct nand_buffers { * @block_markbad: [REPLACEABLE] mark a block bad * @cmd_ctrl: [BOARDSPECIFIC] hardwarespecific function for controlling * ALE/CLE/nCE. Also used to write command and address - * @init_size: [BOARDSPECIFIC] hardwarespecific function for setting - * mtd->oobsize, mtd->writesize and so on. - * @id_data contains the 8 bytes values of NAND_CMD_READID. - * Return with the bus width. * @dev_ready: [BOARDSPECIFIC] hardwarespecific function for accessing * device ready/busy line. If set to NULL no access to * ready/busy is available and the ready/busy information @@ -669,11 +695,9 @@ struct nand_chip { void (*write_buf)(struct mtd_info *mtd, const uint8_t *buf, int len); void (*read_buf)(struct mtd_info *mtd, uint8_t *buf, int len); void (*select_chip)(struct mtd_info *mtd, int chip); - int (*block_bad)(struct mtd_info *mtd, loff_t ofs, int getchip); + int (*block_bad)(struct mtd_info *mtd, loff_t ofs); int (*block_markbad)(struct mtd_info *mtd, loff_t ofs); void (*cmd_ctrl)(struct mtd_info *mtd, int dat, unsigned int ctrl); - int (*init_size)(struct mtd_info *mtd, struct nand_chip *this, - u8 *id_data); int (*dev_ready)(struct mtd_info *mtd); void (*cmdfunc)(struct mtd_info *mtd, unsigned command, int column, int page_addr); @@ -873,7 +897,6 @@ struct nand_manufacturers { extern struct nand_flash_dev nand_flash_ids[]; extern struct nand_manufacturers nand_manuf_ids[]; -extern int nand_scan_bbt(struct mtd_info *mtd, struct nand_bbt_descr *bd); extern int nand_default_bbt(struct mtd_info *mtd); extern int nand_markbad_bbt(struct mtd_info *mtd, loff_t offs); extern int nand_isreserved_bbt(struct mtd_info *mtd, loff_t offs); @@ -898,7 +921,6 @@ extern int nand_do_read(struct mtd_info *mtd, loff_t from, size_t len, * @chip_delay: R/B delay value in us * @options: Option flags, e.g. 16bit buswidth * @bbt_options: BBT option flags, e.g. NAND_BBT_USE_FLASH - * @ecclayout: ECC layout info structure * @part_probe_types: NULL-terminated array of probe types */ struct platform_nand_chip { @@ -906,7 +928,6 @@ struct platform_nand_chip { int chip_offset; int nr_partitions; struct mtd_partition *partitions; - struct nand_ecclayout *ecclayout; int chip_delay; unsigned int options; unsigned int bbt_options; @@ -955,15 +976,6 @@ struct platform_nand_data { struct platform_nand_ctrl ctrl; }; -/* Some helpers to access the data structures */ -static inline -struct platform_nand_chip *get_platform_nandchip(struct mtd_info *mtd) -{ - struct nand_chip *chip = mtd->priv; - - return chip->priv; -} - #ifdef CONFIG_SYS_NAND_ONFI_DETECTION /* return the supported features. */ static inline int onfi_feature(struct nand_chip *chip) @@ -1081,4 +1093,9 @@ struct nand_sdr_timings { /* get timing characteristics from ONFI timing mode. */ const struct nand_sdr_timings *onfi_async_timing_mode_to_sdr_timings(int mode); + +int nand_check_erased_ecc_chunk(void *data, int datalen, + void *ecc, int ecclen, + void *extraoob, int extraooblen, + int threshold); #endif /* __LINUX_MTD_NAND_H */ |