diff options
| -rw-r--r-- | MAINTAINERS | 1 | ||||
| -rw-r--r-- | doc/device-tree-bindings/video/syncoam,seps525.txt | 24 |
2 files changed, 25 insertions, 0 deletions
diff --git a/MAINTAINERS b/MAINTAINERS index 52d7307525..8e2ccc24df 100644 --- a/MAINTAINERS +++ b/MAINTAINERS @@ -548,6 +548,7 @@ S: Maintained T: git https://gitlab.denx.de/u-boot/custodians/u-boot-microblaze.git F: arch/arm/mach-zynq/ F: doc/board/xilinx/ +F: doc/device-tree-bindings/video/syncoam,seps525.txt F: drivers/clk/clk_zynq.c F: drivers/fpga/zynqpl.c F: drivers/gpio/zynq_gpio.c diff --git a/doc/device-tree-bindings/video/syncoam,seps525.txt b/doc/device-tree-bindings/video/syncoam,seps525.txt new file mode 100644 index 0000000000..e1e0db9d71 --- /dev/null +++ b/doc/device-tree-bindings/video/syncoam,seps525.txt @@ -0,0 +1,24 @@ +spi based seps525 framebuffer display driver + +Driver for seps525 display controller (in spi mode), This binding supports selection +of spi chipselect, spi max frequency, gpio to drive dc and reset pin of seps525 +controller and spi transaction bit length. + +Required properties: +- compatible: "syncoam,seps525" +- reg: Specifies the chip-select the seps525 is connected to on the spi bus +- reset-gpios: gpio connected to reset pin of seps525 controller. +- dc-gpios: gpio connected to dc pin of seps525 controller: +- buswidth: bitlength of each spi transaction + +Example: + displayspi@0 { + compatible = "syncoam,seps525"; + reg = <0>; + spi-max-frequency = <10000000>; + spi-cpol; + spi-cpha; + buswidth = <8>; + reset-gpios = <&gpio 0x1c GPIO_ACTIVE_LOW>; + dc-gpios = <&gpio 0x1b GPIO_ACTIVE_HIGH>; + }; |