diff options
| author | Codrin Ciubotariu <codrin.ciubotariu@freescale.com> | 2015-12-15 15:21:06 +0200 |
|---|---|---|
| committer | Joe Hershberger <joe.hershberger@ni.com> | 2016-01-28 12:22:19 -0600 |
| commit | aae0e68909bf2ef1b60d18c54105ab8b9c67c5a2 (patch) | |
| tree | 5ee618d3daa2488bf3cd18d0d8caaa03b84e75a3 /doc | |
| parent | bf9f2ed83b16c6d037609278f66dbf54f40b1903 (diff) | |
| download | u-boot-aae0e68909bf2ef1b60d18c54105ab8b9c67c5a2.tar.gz u-boot-aae0e68909bf2ef1b60d18c54105ab8b9c67c5a2.tar.xz u-boot-aae0e68909bf2ef1b60d18c54105ab8b9c67c5a2.zip | |
drivers: net: vsc9953: Add LAG support
You can now configure LAG on VSC9953's ports using the command:
ethsw [port <port_no>] aggr {[help] | show | <lag_group_no>}
A port must belong to a single LAG. By default, a port
belongs to a LAG equal to the port's number.
For each frame, a hash will be calculated based on
Source/Destination MAC addresses, Source/Destination IP(v4/v6)
addresses, Source/Destination ports. This hash will be used to
select a single egress port from LAG. This also assures
that frames from the same flow will always have the
same egress port.
Signed-off-by: Codrin Ciubotariu <codrin.ciubotariu@freescale.com>
Acked-by: Joe Hershberger <joe.hershberger@ni.com>
Diffstat (limited to 'doc')
| -rw-r--r-- | doc/README.t1040-l2switch | 2 |
1 files changed, 2 insertions, 0 deletions
diff --git a/doc/README.t1040-l2switch b/doc/README.t1040-l2switch index 4e0f418c7c..6f03de239e 100644 --- a/doc/README.t1040-l2switch +++ b/doc/README.t1040-l2switch @@ -31,6 +31,7 @@ Commands supported - Port-based VLAN - Private/Shared VLAN learning - VLAN ingress filtering + - Port LAG Commands syntax ethsw [port <port_no>] { enable | disable | show } - enable/disable a port; show a port's configuration @@ -45,6 +46,7 @@ ethsw [port <port_no>] egress tag { [help] | show | pvid | classified } - config Tag's VID could be the frame's classified VID or the PVID of the port ethsw vlan fdb { [help] | show | shared | private } - make VLAN learning shared or private ethsw [port <port_no>] ingress filtering { [help] | show | enable | disable } - enable/disable VLAN ingress filtering on port +ethsw [port <port_no>] aggr { [help] | show | <lag_group_no> } - get/set LAG group for a port => ethsw show Port Status Link Speed Duplex |