diff options
| author | Tom Rini <trini@konsulko.com> | 2018-01-10 08:05:57 -0500 |
|---|---|---|
| committer | Tom Rini <trini@konsulko.com> | 2018-01-10 08:05:57 -0500 |
| commit | 084edbb6892b3712e2f9fd3abd5871652492fc42 (patch) | |
| tree | 1f26fd21cc86177d6ba76cb88ca60c1772d8c5f9 /board | |
| parent | ec75fab302a8b2ddf291cc1b7219b0333cea1a4d (diff) | |
| parent | 0a05bf42b462c0fd0299c768560c5ad532cdf619 (diff) | |
| download | u-boot-084edbb6892b3712e2f9fd3abd5871652492fc42.tar.gz u-boot-084edbb6892b3712e2f9fd3abd5871652492fc42.tar.xz u-boot-084edbb6892b3712e2f9fd3abd5871652492fc42.zip | |
Merge git://git.denx.de/u-boot-marvell
Diffstat (limited to 'board')
| -rw-r--r-- | board/solidrun/clearfog/README | 21 |
1 files changed, 17 insertions, 4 deletions
diff --git a/board/solidrun/clearfog/README b/board/solidrun/clearfog/README index ef1e3bf426..a7bc0d4e23 100644 --- a/board/solidrun/clearfog/README +++ b/board/solidrun/clearfog/README @@ -17,16 +17,29 @@ $ sudo dd if=u-boot-spl.kwb of=/dev/sdX bs=512 seek=1 Please use the correct device node for your setup instead of "/dev/sdX" here! +Boot selection: +--------------- + +Before powering up the board, boot selection should be done via the SW1 dip +switch (0: OFF, 1: ON): + + - SPI: 00010 + - SD/eMMC: 00111 + - M.2 SSD: 11100 + - UART: 01001 [1] + +[1]: According to SolidRun's manual, 11110 should be used for UART booting on + the ClearFog 'Pro' variant. + However, this doesn't work (anymore) at least on Rev. 2.1 (but '01001' as + mentionend for the 'Base' variant does). + Boot from UART: --------------- Connect the on-board micro-USB (CF Pro: CON11, CF Base: CON5) to your host. -Set the SW1 DIP switches to UART boot (0: OFF, 1: ON): - - ClearFog Base: 01001 - ClearFog Pro: 11110 +Set the SW1 DIP switches to UART boot (see above). Run the following command to initiate U-Boot download: |