Possible problems:
------------------

* If you get an error stating

"possibly undefined macro: AC_PROG_INTLTOOL"

when running ./autogen.sh you need to install the "intltool"
package. On Debian

"apt-get install intltool"

will do that for you.


------------------------------------------------------------

* If you get an error stating

"checking for XML::Parser... configure: error: XML::Parser perl module is required for intltool"

you need to install the libxml-parser package. On Debian

"apt-get install libxml-parser-perl"

will do that for you.


------------------------------------------------------------

* "/bin/sh: ../mkinstalldirs: No such file or directory"

If you get this error, you are probably using automake >= 1.8.
Automake 1.8 does no longer install the mkinstalldirs file, and
gettext 0.14.4 does still depend on it...

Do a 'locate gettext/mkinstalldirs' and copy it over, then run
./autogen.sh again for good measure.

------------------------------------------------------------

* "config.status: error: cannot find input file: po/Makefile.in.in"

Upgrade intltool. 0.33 seems to work.

------------------------------------------------------------

* Compiling for 64bit systems

The current automake/autobuild setup doesn't set the correct
installation path on 64bit systems. To work around this issue and to
get the libraries installed in the correct locations you need to
pecify a couple extra parameters to autoge .sh (or configure). If your
installation prefix is '/opt/gnome' use the following:

./autogen.sh --prefix=/opt/gnome --enable-libsuffix=64 --libdir=/opt/gnome/lib6

If you use a diferent prefix, replace '/opt/gnome' accordingly.

Can someone send a patch how to automate all this?
(gtkpod-devel@lists.sourceforge.net)