# This is test driver for testing two rsyslog instances. It can be # utilized by any test that just needs two instances with different # config files, where messages are injected in instance TWO and # (with whatever rsyslog mechanism) being relayed over to instance ONE, # where they are written to the log file. After the run, the completeness # of that log file is checked. # The code is almost the same, but the config files differ (probably greatly) # for different test cases. As such, this driver needs to be called with the # config file name ($2). From that name, the sender and receiver config file # names are automatically generated. # So: $1 config file name, $2 number of messages # # A note on TLS testing: the current testsuite (in git!) already contains # TLS test cases. However, getting these test cases correct is not simple. # That's not a problem with the code itself, but rater a problem with # synchronization in the test environment. So I have deciced to keep the # TLS tests in, but not yet actually utilize them. This is most probably # left as an excercise for future (devel) releases. -- rgerhards, 2009-11-11 # # added 2009-11-11 by Rgerhards # This file is part of the rsyslog project, released under GPLv3 # uncomment for debugging support: source $srcdir/diag.sh init # start up the instances #export RSYSLOG_DEBUG="debug nostdout noprintmutexaction" #export RSYSLOG_DEBUGLOG="log" source $srcdir/diag.sh startup $1_rcvr.conf source $srcdir/diag.sh wait-startup #export RSYSLOG_DEBUGLOG="log2" #valgrind="valgrind" source $srcdir/diag.sh startup $1_sender.conf 2 source $srcdir/diag.sh wait-startup 2 # may be needed by TLS (once we do it): sleep 30 # now inject the messages into instance 2. It will connect to instance 1, # and that instance will record the data. source $srcdir/diag.sh tcpflood 127.0.0.1 13514 1 $2 1 # shut down sender when everything is sent, receiver continues to run concurrently # may be needed by TLS (once we do it): sleep 60 source $srcdir/diag.sh shutdown-when-empty 2 source $srcdir/diag.sh wait-shutdown 2 # now it is time to stop the receiver as well source $srcdir/diag.sh shutdown-when-empty source $srcdir/diag.sh wait-shutdown # may be needed by TLS (once we do it): sleep 60 # do the final check source $srcdir/diag.sh seq-check 1 $2 source $srcdir/diag.sh exit