RainerScript

RainerScript is a scripting language specifically designed and well-suited for processing network events and configuring event processors (with the most prominent sample being syslog). While RainerScript is theoritically usable with various softwares, it currently is being used, and developed for, rsyslog. Please note that RainerScript may not be abreviated as rscript, because that's somebody elses trademark.

RainerScript is currently under development. It has its first appearance in rsyslog 3.12.0, where it provides complex expression support. However, this is only a very partial implementatio of the scripting language. Due to technical restrictions, the final implementation will have a slightly different syntax. So while you are invited to use the full power of expresssions, you unfortunatley need to be prepared to change your configuration files at some later points. Maintaining backwards-compatibility at this point would cause us to make too much compromise. Defering the release until everything is perfect is also not a good option. So use your own judgement.

A formal definition of the language can be found in RainerScript ABNF. The rest of this document describes the language from the user's point of view. Please note that this doc is also currently under development and can (and will) probably improve as time progresses. If you have questions, use the rsyslog forum. Feedback is also always welcome.

Data Types

RainerScript is a typeless language. That doesn't imply you don't need to care about types. Of course, expressions like "A" + "B" will not return a valid result, as you can't really add two letters (to concatenate them, use the concatenation operator &).  However, all type conversions are automatically done by the script interpreter when there is need to do so.

Expressions

The language supports arbitrary complex expressions. All usual operators are supported. The precedence of operations is as follows (with operations being higher in the list being carried out before those lower in the list, e.g. multiplications are done before additions.
For example, "not a == b" probably returns not what you intended. The script processor will first evaluate "not a" and then compare the resulting boolean to the value of b. What you probably intended to do is "not (a == b)". And if you just want to test for inequality, we highly suggest to use "!=" or "<>". Both are exactly the same and are provided so that you can pick whichever you like best. So inquality of a and b should be tested as "a <> b". The "not" operator should be reserved to cases where it actually is needed to form a complex boolean expression. In those cases, parenthesis are highly recommended.

[rsyslog.conf overview] [manual index] [rsyslog site]

This documentation is part of the rsyslog project.
Copyright © 2008 by Rainer Gerhards and Adiscon. Released under the GNU GPL version 3 or higher.