From 4152e0a5099462a92991f146fceea9c95f3dc938 Mon Sep 17 00:00:00 2001
From: Rainer Gerhards
Date: Fri, 20 Apr 2012 07:28:34 +0200
Subject: doc: omudpspoof doc had invalid directives
Thanks to Jo Rhett for reporting the bug.
---
doc/omudpspoof.html | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
(limited to 'doc')
diff --git a/doc/omudpspoof.html b/doc/omudpspoof.html
index 16cb9b13..631a0878 100644
--- a/doc/omudpspoof.html
+++ b/doc/omudpspoof.html
@@ -16,7 +16,7 @@ spoof the sender address. Also, it enables to circle through a number of
source ports.
Configuration Directives:
-- $ActionOMUDPSpoofSourceNameTemplate <templatename>
+ - $ActionOMOMUDPSpoofSourceNameTemplate <templatename>
This is the name of the template that contains a
numerical IP address that is to be used as the source system IP address.
While it may often be a constant value, it can be generated as usual via the
@@ -28,7 +28,7 @@ So in essence, the default template spoofs the address of the system the message
was received from. This is considered the most important use case.
- $ActionOMUDPSpoofTargetHost <hostname>
Host that the messages shall be sent to.
- - $ActionUDPSpoofTargetPort <port>
+ - $ActionOMUDPSpoofTargetPort <port>
Remote port that the messages shall be sent to.
- $ActionOMUDPSpoofDefaultTemplate <templatename>
This setting instructs omudpspoof to use a template different from the
--
cgit
From 354a410fad173b88c3b121376c2aca7898869ff0 Mon Sep 17 00:00:00 2001
From: Rainer Gerhards
Date: Fri, 20 Apr 2012 07:39:08 +0200
Subject: doc: correcting sample section of omudpspoof
again, credits to Jo Rhett for reporting this issue
---
doc/omudpspoof.html | 16 ++++++++--------
1 file changed, 8 insertions(+), 8 deletions(-)
(limited to 'doc')
diff --git a/doc/omudpspoof.html b/doc/omudpspoof.html
index 631a0878..df14bbe1 100644
--- a/doc/omudpspoof.html
+++ b/doc/omudpspoof.html
@@ -53,7 +53,7 @@ care about the source port. This example is considered the typical use case for
omudpspoof.
@@ -64,10 +64,10 @@ source port 514 is used.
The following sample is similar to the previous, but uses as many defaults as possible.
@@ -77,8 +77,8 @@ have been changed, the previously set defaults will be used!
[rsyslog.conf overview]
@@ -86,7 +86,7 @@ $ActionUDPSpoofTargetHost server.example.com
This documentation is part of the
rsyslog
project.
-Copyright © 2009 by Rainer Gerhards and
+Copyright © 2009-2012 by Rainer Gerhards and
Adiscon.
Released under the GNU GPL version 3 or higher.