diff options
Diffstat (limited to 'doc')
| -rw-r--r-- | doc/queues.html | 19 |
1 files changed, 17 insertions, 2 deletions
diff --git a/doc/queues.html b/doc/queues.html index 3037ee42..58bbfb71 100644 --- a/doc/queues.html +++ b/doc/queues.html @@ -292,7 +292,9 @@ cancelled and the queue is brought down.</p> parameter can be set to "on". This requires either a disk or disk-assisted queue. If set, rsyslogd ensures that any queue elements are saved to disk before it terminates. This includes data elements there were begun being processed by -workers that needed to be cancelled due to too-long processing.</p> +workers that needed to be cancelled due to too-long processing. For a large +queue, this operation may be lengthy. No timeout applies to a required shutdown +save.</p> <h1>Where are Queues Used?</h1> <p> Currently, queues are used for the main message queue and for the actions.</p> @@ -304,7 +306,20 @@ message queue.</p> <p>There are multiple action queues, one for each configured action. By default, these queues operate in direct (non-queueing) mode. Action queues are fully configurable and thus can be changed to whatever is best for the given use case.</p> -<p>Future versions of rsyslog will utilize queues at other places, too.</p> +<p>Future versions of rsyslog will most probably utilize queues at other places, +too.</p> +<p>Whereever "<i><object></i>" was used above in the config file +statements, substitute "<i><object></i>" with either "MainMsg" or "Action". The +former will set main message queue paremeters, the later parameters for the next +action that will be created. Action queue parameters can not be modified once +the action has been specified. For example, to tell the main message queue to +save its content on shutdown, use <i>$MainMsgQueueSaveOnShutdown on</i>".</p> +<p>If the same parameter is specified multiple times before a queue is created, +the last one specified takes precedence. The main message queue is created after +parsing the config file and all of its potential includes. An action queue is +created each time an action selector is specified. Action queue parameters are +reset to default after an action queue has been created (to provide a clean +environment for the next action).</p> <p>Not all queues necessarily support the full set of queue configuration parameters, because not all are applicable. For example, in current output module design, actions do not support multi-threading. Consequently, the number |