diff options
Diffstat (limited to 'doc/rsyslog_conf_global.html')
| -rw-r--r-- | doc/rsyslog_conf_global.html | 11 |
1 files changed, 11 insertions, 0 deletions
diff --git a/doc/rsyslog_conf_global.html b/doc/rsyslog_conf_global.html index 5f80f92e..66a326fe 100644 --- a/doc/rsyslog_conf_global.html +++ b/doc/rsyslog_conf_global.html @@ -58,6 +58,7 @@ default template for UDP and plain TCP forwarding action</li> <li>$ActionGSSForwardDefaultTemplate [templateName] - sets a new default template for GSS-API forwarding action</li> <li>$ActionQueueCheckpointInterval <number></li> +<li>$ActionQueueDequeueBatchSize <number> [default 16]</li> <li>$ActionQueueDequeueSlowdown <number> [number is timeout in <i> micro</i>seconds (1000000us is 1sec!), default 0 (no delay). Simple rate-limiting!]</li> @@ -109,6 +110,14 @@ that it should be not be much more often than once per second).</li> <li><b>$ActionSendUDPRebindInterval</b> nbr</a>- [available since 4.3.2] - instructs the UDP send action to rebind the send socket every nbr of messages sent. Zero, the default, means that no rebind is done. This directive is useful for use with load-balancers.</li> +<li><b>$ActionWriteAllMarkMessages</b> [on/<b>off</b>]- [available since 5.1.5] - normally, mark messages +are written to actions only if the action was not recently executed (by default, recently means within the +past 20 minutes). If this setting is switched to "on", mark messages are always sent to actions, +no matter how recently they have been executed. In this mode, mark messages can be used as a kind of +heartbeat. Note that this option auto-resets to "off", so if you intend to use it with multiple +actions, it must be specified in front off <b>all</b> selector lines that should provide this +functionality. +</li> <li><a href="rsconf1_allowedsender.html">$AllowedSender</a></li> <li><a href="rsconf1_controlcharacterescapeprefix.html">$ControlCharacterEscapePrefix</a></li> <li><a href="rsconf1_debugprintcfsyslinehandlerlist.html">$DebugPrintCFSyslineHandlerList</a></li> @@ -153,6 +162,8 @@ something along the lines of "/etc/init.d/rsyslog restart". rsyslog emits message on startup and shutdown as well as when it is HUPed. This information might be needed by some log analyzers. If set to off, no such status messages are logged, what may be useful for other scenarios. +[available since 4.7.0 and 5.3.0] +<li><b>$MainMsgQueueDequeueBatchSize</b> <number> [default 32]</li> <li>$MainMsgQueueDequeueSlowdown <number> [number is timeout in <i> micro</i>seconds (1000000us is 1sec!), default 0 (no delay). Simple rate-limiting!]</li> |