diff options
Diffstat (limited to 'doc/rsyslog_conf_global.html')
| -rw-r--r-- | doc/rsyslog_conf_global.html | 4 |
1 files changed, 2 insertions, 2 deletions
diff --git a/doc/rsyslog_conf_global.html b/doc/rsyslog_conf_global.html index 50d83a50..e7897f90 100644 --- a/doc/rsyslog_conf_global.html +++ b/doc/rsyslog_conf_global.html @@ -211,9 +211,9 @@ supported in order to be compliant to the upcoming new syslog RFC series. of the output file. The higher the number, the better the compression, but also the more CPU is required for zipping.</li> <li><b>$OMFileIOBufferSize</b> <size_nbr>, default 4k, size of the buffer used to writing output data. The larger the buffer, the potentially better performance is. The default of 4k is quite conservative, it is useful to go up to 64k, and 128K if you used gzip compression (then, even higher sizes may make sense)</li> -<li><b>$OMFileFlushOnTXEnd</b> <[<b>on</b>/off]>, default on. Omfile has the +<li><b>$OMFileFlushOnTXEnd</b> <[on/<b>off</b>]>, default ff. Omfile has the capability to -writes output using a buffered writer. Disk writes are only done when the buffer is +write output using a buffered writer. Disk writes are only done when the buffer is full. So if an error happens during that write, data is potentially lost. In cases where this is unacceptable, set $OMFileFlushOnTXEnd to on. Then, data is written at the end of each transaction (for pre-v5 this means after <b>each</b> log message) and the usual |