diff options
Diffstat (limited to 'doc/imptcp.html')
| -rw-r--r-- | doc/imptcp.html | 26 |
1 files changed, 25 insertions, 1 deletions
diff --git a/doc/imptcp.html b/doc/imptcp.html index c7a0e599..4307c603 100644 --- a/doc/imptcp.html +++ b/doc/imptcp.html @@ -43,9 +43,33 @@ very limited interest in fixing this issue. This directive <b>can not</b> fix th That would require much more code changes, which I was unable to do so far. Full details can be found at the <a href="http://www.rsyslog.com/Article321.phtml">Cisco tcp syslog anomaly</a> page. +<li><b>$InputPTCPSupportOctetCountedFraming</b> <<b>on</b>|off><br> +If set to "on", the legacy octed-counted framing (similar to RFC5425 framing) is +activated. This is the default and should be left unchanged until you know +very well what you do. It may be useful to turn it off, if you know this framing +is not used and some senders emit multi-line messages into the message stream. +</li> <li>$InputPTCPServerNotifyOnConnectionClose [on/<b>off</b>]<br> instructs imptcp to emit a message if the remote peer closes a connection.<br> -<li>$InputPTCPServerRun <port><br> +<li><b>$InputPTCPServerKeepAlive</b> <on/<b>off</b>><br> +enable of disable keep-alive packets at the tcp socket layer. The default is +to disable them.</li> +<li><b>$InputPTCPServerKeepAlive_probes</b> <number><br> +The number of unacknowledged probes to send before considering the connection dead and notifying the application layer. +The default, 0, means that the operating system defaults are used. This has only +effect if keep-alive is enabled. The functionality may not be available on +all platforms. +<li><b>$InputPTCPServerKeepAlive_intvl</b> <number><br> +The interval between subsequential keepalive probes, regardless of what the connection has exchanged in the meantime. +The default, 0, means that the operating system defaults are used. This has only +effect if keep-alive is enabled. The functionality may not be available on +all platforms. +<li><b>$InputPTCPServerKeepAlive_time</b> <number><br> +The interval between the last data packet sent (simple ACKs are not considered data) and the first keepalive probe; after the connection is marked to need keepalive, this counter is not used any further. +The default, 0, means that the operating system defaults are used. This has only +effect if keep-alive is enabled. The functionality may not be available on +all platforms. +<li><b>$InputPTCPServerRun</b> <port><br> Starts a TCP server on selected port</li> <li>$InputPTCPServerInputName <name><br> Sets a name for the inputname property. If no name is set "imptcp" is used by default. Setting a |