- Greatly enhanced rsyslogd's filw write performance by disabling file

    syncing capability of output modules by default. This feature is
    usually not required, not useful and an extreme performance hit (both
    to rsyslogd as well as the system at large). Unfortunately, most users
    enable it by default, because it was most intuitive to enable it in
    plain old sysklogd syslog.conf format. There is now a new config
    setting which must be enabled in order to support syncing. By default
    it is off. So even if the old-format config lines request syncing, it
    is not done unless explicitely enabled. I am sure this is a very useful
    change and not a risk at all. I need to think if I undo it under
    compatibility mode, but currently this does not happen (I fear a lot of
    lazy users will run rsyslogd in compatibility mode, again bringing up
    this performance problem...).
- added $ActionfileEnableSync config directive

1 files changed, 1 insertions, 1 deletions

diff --git a/doc/rsyslog_conf.html b/doc/rsyslog_conf.html
index 1dc53944..14dad6f6 100644
--- a/doc/rsyslog_conf.html
+++ b/doc/rsyslog_conf.html
@@ -64,7 +64,7 @@ unstable...). So you have been warned ;)</p>
 many parameter settings modify queue parameters. If in doubt, use the
 default, it is usually well-chosen and applicable in most cases.</p>
 <ul>
-<li><a href="rsconf1_actionexeconlywhenpreviousissuspended.html">$ActionExecOnlyWhenPreviousIsSuspended</a></li>
+<li><a href="rsconf1_actionexeconlywhenpreviousissuspended.html">$ActionExecOnlyWhenPreviousIsSuspended</a></li><li>$ActionfileEnableSync [on/<span style="font-weight: bold;">off</span>] - enables file syncing capability of omfile</li>
 <li>$ActionQueueCheckpointInterval &lt;number&gt;</li>
 <li>$ActionQueueDequeueSlowdown &lt;number&gt; [number
 is timeout in <i> micro</i>seconds (1000000us is 1sec!),