diff options
Diffstat (limited to 'arch/i386')
-rw-r--r-- | arch/i386/Kconfig | 6 | ||||
-rw-r--r-- | arch/i386/kernel/acpi/boot.c | 8 | ||||
-rw-r--r-- | arch/i386/kernel/apic.c | 8 | ||||
-rw-r--r-- | arch/i386/kernel/io_apic.c | 5 | ||||
-rw-r--r-- | arch/i386/kernel/mpparse.c | 12 | ||||
-rw-r--r-- | arch/i386/kernel/setup.c | 2 | ||||
-rw-r--r-- | arch/i386/kernel/traps.c | 4 | ||||
-rw-r--r-- | arch/i386/mm/init.c | 2 | ||||
-rw-r--r-- | arch/i386/oprofile/nmi_int.c | 7 | ||||
-rw-r--r-- | arch/i386/power/cpu.c | 2 |
10 files changed, 44 insertions, 12 deletions
diff --git a/arch/i386/Kconfig b/arch/i386/Kconfig index c6fe99e57a0..8dfa3054f10 100644 --- a/arch/i386/Kconfig +++ b/arch/i386/Kconfig @@ -758,10 +758,10 @@ config HOTPLUG_CPU bool "Support for hot-pluggable CPUs (EXPERIMENTAL)" depends on SMP && HOTPLUG && EXPERIMENTAL && !X86_VOYAGER ---help--- - Say Y here to experiment with turning CPUs off and on. CPUs - can be controlled through /sys/devices/system/cpu. + Say Y here to experiment with turning CPUs off and on, and to + enable suspend on SMP systems. CPUs can be controlled through + /sys/devices/system/cpu. - Say N. endmenu diff --git a/arch/i386/kernel/acpi/boot.c b/arch/i386/kernel/acpi/boot.c index 40e5aba3ad3..daee69579b1 100644 --- a/arch/i386/kernel/acpi/boot.c +++ b/arch/i386/kernel/acpi/boot.c @@ -1066,6 +1066,14 @@ static struct dmi_system_id __initdata acpi_dmi_table[] = { DMI_MATCH(DMI_PRODUCT_NAME, "TravelMate 360"), }, }, + { + .callback = disable_acpi_pci, + .ident = "HP xw9300", + .matches = { + DMI_MATCH(DMI_SYS_VENDOR, "Hewlett-Packard"), + DMI_MATCH(DMI_PRODUCT_NAME, "HP xw9300 Workstation"), + }, + }, {} }; diff --git a/arch/i386/kernel/apic.c b/arch/i386/kernel/apic.c index 013b85df18c..3d4b2f3d116 100644 --- a/arch/i386/kernel/apic.c +++ b/arch/i386/kernel/apic.c @@ -1341,6 +1341,14 @@ int __init APIC_init_uniprocessor (void) connect_bsp_APIC(); + /* + * Hack: In case of kdump, after a crash, kernel might be booting + * on a cpu with non-zero lapic id. But boot_cpu_physical_apicid + * might be zero if read from MP tables. Get it from LAPIC. + */ +#ifdef CONFIG_CRASH_DUMP + boot_cpu_physical_apicid = GET_APIC_ID(apic_read(APIC_ID)); +#endif phys_cpu_present_map = physid_mask_of_physid(boot_cpu_physical_apicid); setup_local_APIC(); diff --git a/arch/i386/kernel/io_apic.c b/arch/i386/kernel/io_apic.c index f8f132aa547..d70f2ade5cd 100644 --- a/arch/i386/kernel/io_apic.c +++ b/arch/i386/kernel/io_apic.c @@ -2238,6 +2238,8 @@ static inline void unlock_ExtINT_logic(void) spin_unlock_irqrestore(&ioapic_lock, flags); } +int timer_uses_ioapic_pin_0; + /* * This code may look a bit paranoid, but it's supposed to cooperate with * a wide range of boards and BIOS bugs. Fortunately only the timer IRQ @@ -2274,6 +2276,9 @@ static inline void check_timer(void) pin2 = ioapic_i8259.pin; apic2 = ioapic_i8259.apic; + if (pin1 == 0) + timer_uses_ioapic_pin_0 = 1; + printk(KERN_INFO "..TIMER: vector=0x%02X apic1=%d pin1=%d apic2=%d pin2=%d\n", vector, apic1, pin1, apic2, pin2); diff --git a/arch/i386/kernel/mpparse.c b/arch/i386/kernel/mpparse.c index 34d21e21e01..6b1392d33ed 100644 --- a/arch/i386/kernel/mpparse.c +++ b/arch/i386/kernel/mpparse.c @@ -1130,7 +1130,17 @@ int mp_register_gsi (u32 gsi, int triggering, int polarity) */ int irq = gsi; if (gsi < MAX_GSI_NUM) { - if (gsi > 15) + /* + * Retain the VIA chipset work-around (gsi > 15), but + * avoid a problem where the 8254 timer (IRQ0) is setup + * via an override (so it's not on pin 0 of the ioapic), + * and at the same time, the pin 0 interrupt is a PCI + * type. The gsi > 15 test could cause these two pins + * to be shared as IRQ0, and they are not shareable. + * So test for this condition, and if necessary, avoid + * the pin collision. + */ + if (gsi > 15 || (gsi == 0 && !timer_uses_ioapic_pin_0)) gsi = pci_irq++; /* * Don't assign IRQ used by ACPI SCI diff --git a/arch/i386/kernel/setup.c b/arch/i386/kernel/setup.c index d77e89ac0d5..846e1639ef7 100644 --- a/arch/i386/kernel/setup.c +++ b/arch/i386/kernel/setup.c @@ -1320,6 +1320,8 @@ legacy_init_iomem_resources(struct resource *code_resource, struct resource *dat probe_roms(); for (i = 0; i < e820.nr_map; i++) { struct resource *res; + if (e820.map[i].addr + e820.map[i].size > 0x100000000ULL) + continue; res = kzalloc(sizeof(struct resource), GFP_ATOMIC); switch (e820.map[i].type) { case E820_RAM: res->name = "System RAM"; break; diff --git a/arch/i386/kernel/traps.c b/arch/i386/kernel/traps.c index 2d22f5761b1..0e498369f35 100644 --- a/arch/i386/kernel/traps.c +++ b/arch/i386/kernel/traps.c @@ -130,9 +130,8 @@ static inline int print_addr_and_symbol(unsigned long addr, char *log_lvl, print_symbol("%s", addr); printed = (printed + 1) % CONFIG_STACK_BACKTRACE_COLS; - if (printed) - printk(" "); + printk(" "); else printk("\n"); @@ -212,7 +211,6 @@ static void show_stack_log_lvl(struct task_struct *task, unsigned long *esp, } stack = esp; - printk(log_lvl); for(i = 0; i < kstack_depth_to_print; i++) { if (kstack_end(stack)) break; diff --git a/arch/i386/mm/init.c b/arch/i386/mm/init.c index ae6534ad816..3df1371d452 100644 --- a/arch/i386/mm/init.c +++ b/arch/i386/mm/init.c @@ -651,7 +651,7 @@ void __init mem_init(void) * Specifically, in the case of x86, we will always add * memory to the highmem for now. */ -#ifdef CONFIG_HOTPLUG_MEMORY +#ifdef CONFIG_MEMORY_HOTPLUG #ifndef CONFIG_NEED_MULTIPLE_NODES int add_memory(u64 start, u64 size) { diff --git a/arch/i386/oprofile/nmi_int.c b/arch/i386/oprofile/nmi_int.c index 1a2076ce6f6..ec0fd3cfa77 100644 --- a/arch/i386/oprofile/nmi_int.c +++ b/arch/i386/oprofile/nmi_int.c @@ -332,10 +332,11 @@ static int __init ppro_init(char ** cpu_type) { __u8 cpu_model = boot_cpu_data.x86_model; - if (cpu_model > 0xd) + if (cpu_model == 14) + *cpu_type = "i386/core"; + else if (cpu_model > 0xd) return 0; - - if (cpu_model == 9) { + else if (cpu_model == 9) { *cpu_type = "i386/p6_mobile"; } else if (cpu_model > 5) { *cpu_type = "i386/piii"; diff --git a/arch/i386/power/cpu.c b/arch/i386/power/cpu.c index 50a0bef8c85..79b2370c7fa 100644 --- a/arch/i386/power/cpu.c +++ b/arch/i386/power/cpu.c @@ -92,7 +92,7 @@ void __restore_processor_state(struct saved_context *ctxt) write_cr4(ctxt->cr4); write_cr3(ctxt->cr3); write_cr2(ctxt->cr2); - write_cr2(ctxt->cr0); + write_cr0(ctxt->cr0); /* * now restore the descriptor tables to their proper values |