1.0 This is an IP address. Both IPv4 and IPv6 addresses are supported, as well as NIC link monitoring for each IP address. This is an IP address. IPv4 or IPv6 address to use as a virtual IP resource. It may be followed by a slash and a decimal number that encodes the network prefix length. IP Address IPv4 or IPv6 address protocol family. Family Enabling this causes the status check to fail if the link on the NIC to which this IP address is bound is not present. Monitor NIC Link If set and unmounting the file system fails, the node will try to kill lockd and issue reclaims across all remaining network interface cards. Enable NFS lock workarounds Amount of time to sleep after removing an IP address. Value is specified in seconds. Default value is 10. Amount of time (seconds) to sleep. Disable updating of routing using RDISC protocol and preserve static routes. Disable updating of routing using RDISC protocol The network interface to which the IP address should be added. The interface must already be configured and active. This parameter should be used only when at least two active interfaces have IP addresses on the same subnet and it is desired to have the IP address added to a particular interface. Network interface