summaryrefslogtreecommitdiffstats
path: root/arch/arm/plat-samsung/include/plat/gpio-cfg.h
diff options
context:
space:
mode:
Diffstat (limited to 'arch/arm/plat-samsung/include/plat/gpio-cfg.h')
-rw-r--r--arch/arm/plat-samsung/include/plat/gpio-cfg.h6
1 files changed, 3 insertions, 3 deletions
diff --git a/arch/arm/plat-samsung/include/plat/gpio-cfg.h b/arch/arm/plat-samsung/include/plat/gpio-cfg.h
index 5e04fa6eda74..1762dcb4cb9e 100644
--- a/arch/arm/plat-samsung/include/plat/gpio-cfg.h
+++ b/arch/arm/plat-samsung/include/plat/gpio-cfg.h
@@ -125,7 +125,7 @@ extern int s3c_gpio_cfgpin_range(unsigned int start, unsigned int nr,
*
* These values control the state of the weak pull-{up,down} resistors
* available on most pins on the S3C series. Not all chips support both
- * up or down settings, and it may be dependant on the chip that is being
+ * up or down settings, and it may be dependent on the chip that is being
* used to whether the particular mode is available.
*/
#define S3C_GPIO_PULL_NONE ((__force s3c_gpio_pull_t)0x00)
@@ -138,7 +138,7 @@ extern int s3c_gpio_cfgpin_range(unsigned int start, unsigned int nr,
* @pull: The configuration for the pull resistor.
*
* This function sets the state of the pull-{up,down} resistor for the
- * specified pin. It will return 0 if successfull, or a negative error
+ * specified pin. It will return 0 if successful, or a negative error
* code if the pin cannot support the requested pull setting.
*
* @pull is one of S3C_GPIO_PULL_NONE, S3C_GPIO_PULL_DOWN or S3C_GPIO_PULL_UP.
@@ -202,7 +202,7 @@ extern s5p_gpio_drvstr_t s5p_gpio_get_drvstr(unsigned int pin);
* @drvstr: The new value of the driver strength
*
* This function sets the driver strength value for the specified pin.
- * It will return 0 if successfull, or a negative error code if the pin
+ * It will return 0 if successful, or a negative error code if the pin
* cannot support the requested setting.
*/
extern int s5p_gpio_set_drvstr(unsigned int pin, s5p_gpio_drvstr_t drvstr);