| -V |
display verbose output. |
| -l |
lifetime
requests a ticket with the lifetime lifetime. The value for
lifetime must be followed immediately by one of the following
delimiters:
- s seconds
- m minutes
- h hours
- d days
as in "kinit -l 90m". You cannot mix units; a value of `3h30m'
will result in an error.
If the -l option is not specified, the default ticket lifetime
(configured by each site) is used. Specifying a ticket lifetime
longer than the maximum ticket lifetime (configured by each
site) results in a ticket with the maximum lifetime.
|
| -s start_time |
requests a postdated ticket, valid starting at -start_time. Postdated tickets are issued with the invalid flag set, and need to be fed back to the kdc before use. |
|---|
| -r renewable_life |
requests renewable tickets, with a total lifetime of -renewable_life. The duration is in the same format as the -l option, with the same delimiters. |
| -f |
request forwardable tickets. |
| -F |
do not request forwardable tickets. |
| -p |
request proxiable tickets. |
| -P |
do not request proxiable tickets. |
| -a |
request tickets with the local address[es]. |
| -A |
request address-less tickets. |
| -k [-t keytab_file] |
requests a ticket, obtained from a key in the local host's
keytab file. The name and location of the keytab file may be
specified with the -t keytab_file option; otherwise the default
name and location will be used. By default a host ticket is
requested but any principal may be specified. On a KDC, the special
keytab location KDB: can be used to indicate that kinit
should open the KDC database and look up the key directly. This
permits an administrator to obtain tickets as any principal that
supports password-based authentication. |
| -n |
Requests anonymous processing. Two types of anonymous principals
are supported. For fully anonymous Kerberos, configure pkinit on the
KDC and configure pkinit_anchors in the client's
krb5.conf. Then use the -n option with a principal of the form
@REALM (an empty principal name followed by the at-sign and a
realm name). If permitted by the KDC, an anonymous ticket will
be returned. A second form of anonymous tickets is supported;
these realm-exposed tickets hide the identity of the client but
not the client's realm. For this mode, use kinit -n with a normal principal name. If supported by the KDC, the principal (but
not realm) will be replaced by the anonymous principal. As of
release 1.8, the MIT Kerberos KDC only supports fully anonymous
operation. |
| -T armor_ccache |
Specifies the name of a credential cache that already contains a
ticket. If supported by the KDC, This ccache will be used to
armor the request so that an attacker would have to know both
the key of the armor ticket and the key of the principal used
for authentication in order to attack the request. Armoring also
makes sure that the response from the KDC is not modified in
transit. |
| -c cache_name |
use cache_name
as the Kerberos 5 credentials (ticket) cache name and location; if this
option is not used, the default cache name and location are used. The
default credentials cache may vary between systems. If the KRB5CCNAME environment variable is set, its value is used to
name the default ticket cache. If a principal name is specified
and the type of the default credentials cache supports a collection
(such as the DIR type), an existing cache containing credentials
for the principal is selected or a new one is created
and becomes the new primary cache. Otherwise, any existing contents
of the default cache are destroyed by kinit. |
| -S service_name |
specify an alternate service name to use when getting initial
tickets. |
| flag_RSA_PROTOCOL[=yes] |
specify use of RSA, rather than the default Diffie-Hellman protocol. |