From debb7354d1ea4f694154818df5e5b523f5c1cc1d Mon Sep 17 00:00:00 2001 From: Jon Loeliger Date: Wed, 26 Apr 2006 17:58:56 -0500 Subject: Initial support for MPC8641 HPCN board. --- include/common.h | 11 ++++++++++- 1 file changed, 10 insertions(+), 1 deletion(-) (limited to 'include/common.h') diff --git a/include/common.h b/include/common.h index 5d8b15628b..83ccf7c987 100644 --- a/include/common.h +++ b/include/common.h @@ -79,6 +79,10 @@ typedef volatile unsigned char vu_char; #endif #include #endif +#ifdef CONFIG_MPC86xx +#include +#include +#endif #ifdef CONFIG_MPC85xx #include #include @@ -366,6 +370,7 @@ void trap_init (ulong); defined (CONFIG_74xx) || \ defined (CONFIG_MPC8220) || \ defined (CONFIG_MPC85xx) || \ + defined (CONFIG_MPC86xx) || \ defined (CONFIG_MPC83XX) unsigned char in8(unsigned int); void out8(unsigned int, unsigned char); @@ -454,6 +459,10 @@ ulong get_bus_freq (ulong); typedef MPC85xx_SYS_INFO sys_info_t; void get_sys_info ( sys_info_t * ); #endif +#if defined(CONFIG_MPC86xx) +typedef MPC86xx_SYS_INFO sys_info_t; +void get_sys_info ( sys_info_t * ); +#endif #if defined(CONFIG_4xx) || defined(CONFIG_IOP480) # if defined(CONFIG_440) @@ -468,7 +477,7 @@ void get_sys_info ( sys_info_t * ); #if defined(CONFIG_8xx) || defined(CONFIG_8260) void cpu_init_f (volatile immap_t *immr); #endif -#if defined(CONFIG_4xx) || defined(CONFIG_MPC85xx) || defined(CONFIG_MCF52x2) +#if defined(CONFIG_4xx) || defined(CONFIG_MPC85xx) || defined(CONFIG_MCF52x2) ||defined(CONFIG_MPC86xx) void cpu_init_f (void); #endif -- cgit From bea3f28d285942bf3f7ab339ce85178ded544225 Mon Sep 17 00:00:00 2001 From: Haiying Wang Date: Wed, 12 Jul 2006 10:48:05 -0400 Subject: Add support for reading and writing mac addresses to or from ID EEPROM. Added code for reading and writing Mac addresses to/from ID EEPROM(0x57). With attached patch, we can use command "mac/mac read/mac save/" to read and write EEPROM under u-boot prompt. U-boot will calculate the checksum of EEPROM while bootup, if it is right, then u-boot will check whether the mac address of eTSEC0/1/2/3 is availalbe (non-zero). If there is mac address availabe in EEPROM, u-boot will use it, otherewise, u-boot will use the mac address defined in MPC8641HPCN.h. This matches the requirement to set unique mac address for each TSEC port. Signed-off-by: Haiying Wang Signed-off-by: York Sun --- include/common.h | 3 +++ 1 file changed, 3 insertions(+) (limited to 'include/common.h') diff --git a/include/common.h b/include/common.h index 83ccf7c987..7e54da93bf 100644 --- a/include/common.h +++ b/include/common.h @@ -197,6 +197,9 @@ int checkdram (void); char * strmhz(char *buf, long hz); int last_stage_init(void); extern ulong monitor_flash_len; +#ifdef CFG_ID_EEPROM +int mac_read_from_eeprom(void); +#endif /* common/flash.c */ void flash_perror (int); -- cgit