From 8b6684a698500be9c142ec2c9f46cfc348e17f0c Mon Sep 17 00:00:00 2001 From: Haavard Skinnemoen Date: Wed, 24 Oct 2007 15:48:37 +0200 Subject: ATSTK1002: Remove default ethernet addresses Wolfgang is right: It's not a good idea to set up default initial ethernet addresses for a board, even though they belong to the local range. This will change the failure mode from "IT manager screams at you for using duplicate ethernet addresses" to a nice error message explaining that the ethernet address hasn't been set properly. Signed-off-by: Haavard Skinnemoen --- include/configs/atstk1002.h | 11 +++-------- 1 file changed, 3 insertions(+), 8 deletions(-) diff --git a/include/configs/atstk1002.h b/include/configs/atstk1002.h index 1809fc5d86..b33e26fe01 100644 --- a/include/configs/atstk1002.h +++ b/include/configs/atstk1002.h @@ -114,15 +114,10 @@ #define CONFIG_AUTOBOOT_STOP_STR " " /* - * These are "locally administered ethernet addresses" generated by - * ./tools/gen_eth_addr - * - * After booting the board for the first time, new addresses should be - * generated and assigned to the environment variables "ethaddr" and - * "eth1addr". + * After booting the board for the first time, new ethernet addresses + * should be generated and assigned to the environment variables + * "ethaddr" and "eth1addr". This is normally done during production. */ -#define CONFIG_ETHADDR 6a:87:71:14:cd:cb -#define CONFIG_ETH1ADDR ca:f8:15:e6:3e:e6 #define CONFIG_OVERWRITE_ETHADDR_ONCE 1 #define CONFIG_NET_MULTI 1 -- cgit