summaryrefslogtreecommitdiffstats
diff options
context:
space:
mode:
Diffstat
-rw-r--r--arch/arm/cpu/armv7/omap-common/clocks-common.c83
-rw-r--r--arch/arm/cpu/armv7/omap5/hw_data.c43
-rw-r--r--arch/arm/include/asm/arch-omap5/clock.h20
3 files changed, 118 insertions, 28 deletions
diff --git a/arch/arm/cpu/armv7/omap-common/clocks-common.c b/arch/arm/cpu/armv7/omap-common/clocks-common.c
index 8e7411d437..03674e609f 100644
--- a/arch/arm/cpu/armv7/omap-common/clocks-common.c
+++ b/arch/arm/cpu/armv7/omap-common/clocks-common.c
@@ -437,12 +437,15 @@ void do_scale_vcore(u32 vcore_reg, u32 volt_mv, struct pmic_data *pmic)
{
u32 offset_code;
u32 offset = volt_mv;
+#ifndef CONFIG_DRA7XX
int ret = 0;
+#endif
if (!volt_mv)
return;
pmic->pmic_bus_init();
+#ifndef CONFIG_DRA7XX
/* See if we can first get the GPIO if needed */
if (pmic->gpio_en)
ret = gpio_request(pmic->gpio, "PMIC_GPIO");
@@ -456,7 +459,7 @@ void do_scale_vcore(u32 vcore_reg, u32 volt_mv, struct pmic_data *pmic)
/* Pull the GPIO low to select SET0 register, while we program SET1 */
if (pmic->gpio_en)
gpio_direction_output(pmic->gpio, 0);
-
+#endif
/* convert to uV for better accuracy in the calculations */
offset *= 1000;
@@ -467,9 +470,10 @@ void do_scale_vcore(u32 vcore_reg, u32 volt_mv, struct pmic_data *pmic)
if (pmic->pmic_write(pmic->i2c_slave_addr, vcore_reg, offset_code))
printf("Scaling voltage failed for 0x%x\n", vcore_reg);
-
+#ifndef CONFIG_DRA7XX
if (pmic->gpio_en)
gpio_direction_output(pmic->gpio, 1);
+#endif
}
static u32 optimize_vcore_voltage(struct volts const *v)
@@ -505,13 +509,79 @@ static u32 optimize_vcore_voltage(struct volts const *v)
}
/*
- * Setup the voltages for vdd_mpu, vdd_core, and vdd_iva
- * We set the maximum voltages allowed here because Smart-Reflex is not
- * enabled in bootloader. Voltage initialization in the kernel will set
- * these to the nominal values after enabling Smart-Reflex
+ * Setup the voltages for the main SoC core power domains.
+ * We start with the maximum voltages allowed here, as set in the corresponding
+ * vcores_data struct, and then scale (usually down) to the fused values that
+ * are retrieved from the SoC. The scaling happens only if the efuse.reg fields
+ * are initialised.
+ * Rail grouping is supported for the DRA7xx SoCs only, therefore the code is
+ * compiled conditionally. Note that the new code writes the scaled (or zeroed)
+ * values back to the vcores_data struct for eventual reuse. Zero values mean
+ * that the corresponding rails are not controlled separately, and are not sent
+ * to the PMIC.
*/
void scale_vcores(struct vcores_data const *vcores)
{
+#if defined(CONFIG_DRA7XX)
+ int i;
+ struct volts *pv = (struct volts *)vcores;
+ struct volts *px;
+
+ for (i=0; i<(sizeof(struct vcores_data)/sizeof(struct volts)); i++) {
+ debug("%d -> ", pv->value);
+ if (pv->value) {
+ /* Handle non-empty members only */
+ pv->value = optimize_vcore_voltage(pv);
+ px = (struct volts *)vcores;
+ while (px < pv) {
+ /*
+ * Scan already handled non-empty members to see
+ * if we have a group and find the max voltage,
+ * which is set to the first occurance of the
+ * particular SMPS; the other group voltages are
+ * zeroed.
+ */
+ if (px->value) {
+ if ((pv->pmic->i2c_slave_addr ==
+ px->pmic->i2c_slave_addr) &&
+ (pv->addr == px->addr)) {
+ /* Same PMIC, same SMPS */
+ if (pv->value > px->value)
+ px->value = pv->value;
+
+ pv->value = 0;
+ }
+ }
+ px++;
+ }
+ }
+ debug("%d\n", pv->value);
+ pv++;
+ }
+
+ debug("cor: %d\n", vcores->core.value);
+ do_scale_vcore(vcores->core.addr, vcores->core.value, vcores->core.pmic);
+ debug("mpu: %d\n", vcores->mpu.value);
+ do_scale_vcore(vcores->mpu.addr, vcores->mpu.value, vcores->mpu.pmic);
+ /* Configure MPU ABB LDO after scale */
+ abb_setup((*ctrl)->control_std_fuse_opp_vdd_mpu_2,
+ (*ctrl)->control_wkup_ldovbb_mpu_voltage_ctrl,
+ (*prcm)->prm_abbldo_mpu_setup,
+ (*prcm)->prm_abbldo_mpu_ctrl,
+ (*prcm)->prm_irqstatus_mpu_2,
+ OMAP_ABB_MPU_TXDONE_MASK,
+ OMAP_ABB_FAST_OPP);
+
+ /* The .mm member is not used for the DRA7xx */
+
+ debug("gpu: %d\n", vcores->gpu.value);
+ do_scale_vcore(vcores->gpu.addr, vcores->gpu.value, vcores->gpu.pmic);
+ debug("eve: %d\n", vcores->eve.value);
+ do_scale_vcore(vcores->eve.addr, vcores->eve.value, vcores->eve.pmic);
+ debug("iva: %d\n", vcores->iva.value);
+ do_scale_vcore(vcores->iva.addr, vcores->iva.value, vcores->iva.pmic);
+ /* Might need udelay(1000) here if debug is enabled to see all prints */
+#else
u32 val;
val = optimize_vcore_voltage(&vcores->core);
@@ -540,6 +610,7 @@ void scale_vcores(struct vcores_data const *vcores)
val = optimize_vcore_voltage(&vcores->iva);
do_scale_vcore(vcores->iva.addr, val, vcores->iva.pmic);
+#endif
}
static inline void enable_clock_domain(u32 const clkctrl_reg, u32 enable_mode)
diff --git a/arch/arm/cpu/armv7/omap5/hw_data.c b/arch/arm/cpu/armv7/omap5/hw_data.c
index 95f16866e6..b9734fea8f 100644
--- a/arch/arm/cpu/armv7/omap5/hw_data.c
+++ b/arch/arm/cpu/armv7/omap5/hw_data.c
@@ -320,6 +320,7 @@ struct pmic_data palmas = {
.pmic_write = omap_vc_bypass_send_value,
};
+/* The TPS659038 and TPS65917 are software-compatible, use common struct */
struct pmic_data tps659038 = {
.base_offset = PALMAS_SMPS_BASE_VOLT_UV,
.step = 10000, /* 10 mV represented in uV */
@@ -394,34 +395,38 @@ struct vcores_data dra752_volts = {
};
struct vcores_data dra722_volts = {
- .mpu.value = 1000,
+ .mpu.value = VDD_MPU_DRA72x,
.mpu.efuse.reg = STD_FUSE_OPP_VMIN_MPU_NOM,
- .mpu.efuse.reg_bits = DRA752_EFUSE_REGBITS,
- .mpu.addr = 0x23,
+ .mpu.efuse.reg_bits = DRA752_EFUSE_REGBITS,
+ .mpu.addr = TPS65917_REG_ADDR_SMPS1,
.mpu.pmic = &tps659038,
- .eve.value = 1000,
- .eve.efuse.reg = STD_FUSE_OPP_VMIN_DSPEVE_NOM,
- .eve.efuse.reg_bits = DRA752_EFUSE_REGBITS,
- .eve.addr = 0x2f,
- .eve.pmic = &tps659038,
+ .core.value = VDD_CORE_DRA72x,
+ .core.efuse.reg = STD_FUSE_OPP_VMIN_CORE_NOM,
+ .core.efuse.reg_bits = DRA752_EFUSE_REGBITS,
+ .core.addr = TPS65917_REG_ADDR_SMPS2,
+ .core.pmic = &tps659038,
- .gpu.value = 1000,
+ /*
+ * The DSPEVE, GPU and IVA rails are usually grouped on DRA72x
+ * designs and powered by TPS65917 SMPS3, as on the J6Eco EVM.
+ */
+ .gpu.value = VDD_GPU_DRA72x,
.gpu.efuse.reg = STD_FUSE_OPP_VMIN_GPU_NOM,
- .gpu.efuse.reg_bits = DRA752_EFUSE_REGBITS,
- .gpu.addr = 0x2f,
+ .gpu.efuse.reg_bits = DRA752_EFUSE_REGBITS,
+ .gpu.addr = TPS65917_REG_ADDR_SMPS3,
.gpu.pmic = &tps659038,
- .core.value = 1000,
- .core.efuse.reg = STD_FUSE_OPP_VMIN_CORE_NOM,
- .core.efuse.reg_bits = DRA752_EFUSE_REGBITS,
- .core.addr = 0x27,
- .core.pmic = &tps659038,
+ .eve.value = VDD_EVE_DRA72x,
+ .eve.efuse.reg = STD_FUSE_OPP_VMIN_DSPEVE_NOM,
+ .eve.efuse.reg_bits = DRA752_EFUSE_REGBITS,
+ .eve.addr = TPS65917_REG_ADDR_SMPS3,
+ .eve.pmic = &tps659038,
- .iva.value = 1000,
+ .iva.value = VDD_IVA_DRA72x,
.iva.efuse.reg = STD_FUSE_OPP_VMIN_IVA_NOM,
- .iva.efuse.reg_bits = DRA752_EFUSE_REGBITS,
- .iva.addr = 0x2f,
+ .iva.efuse.reg_bits = DRA752_EFUSE_REGBITS,
+ .iva.addr = TPS65917_REG_ADDR_SMPS3,
.iva.pmic = &tps659038,
};
diff --git a/arch/arm/include/asm/arch-omap5/clock.h b/arch/arm/include/asm/arch-omap5/clock.h
index 0dc584b8ce..f8e5630bcb 100644
--- a/arch/arm/include/asm/arch-omap5/clock.h
+++ b/arch/arm/include/asm/arch-omap5/clock.h
@@ -236,13 +236,20 @@
#define VDD_MPU_ES2_LOW 880
#define VDD_MM_ES2_LOW 880
-/* TPS659038 Voltage settings in mv for OPP_NOMINAL */
-#define VDD_MPU_DRA752 1090
+/* DRA74x/75x voltage settings in mv for OPP_NOM per DM */
+#define VDD_MPU_DRA752 1100
#define VDD_EVE_DRA752 1060
#define VDD_GPU_DRA752 1060
-#define VDD_CORE_DRA752 1030
+#define VDD_CORE_DRA752 1060
#define VDD_IVA_DRA752 1060
+/* DRA72x voltage settings in mv for OPP_NOM per DM */
+#define VDD_MPU_DRA72x 1100
+#define VDD_EVE_DRA72x 1060
+#define VDD_GPU_DRA72x 1060
+#define VDD_CORE_DRA72x 1060
+#define VDD_IVA_DRA72x 1060
+
/* Efuse register offsets for DRA7xx platform */
#define DRA752_EFUSE_BASE 0x4A002000
#define DRA752_EFUSE_REGBITS 16
@@ -284,6 +291,13 @@
#define TPS659038_REG_ADDR_SMPS7 0x33
#define TPS659038_REG_ADDR_SMPS8 0x37
+/* TPS65917 */
+#define TPS65917_I2C_SLAVE_ADDR 0x58
+#define TPS65917_REG_ADDR_SMPS1 0x23
+#define TPS65917_REG_ADDR_SMPS2 0x27
+#define TPS65917_REG_ADDR_SMPS3 0x2F
+
+
/* TPS */
#define TPS62361_I2C_SLAVE_ADDR 0x60
#define TPS62361_REG_ADDR_SET0 0x0
generated by cgit (git 2.34.1) at 2024-11-14 01:30:01 +0000