Fix Ethernet init() return codes

Change return values of init() functions in all Ethernet drivers to conform
to the following:

    >=0: Success
    <0:  Failure

All drivers going forward should return 0 on success.  Current drivers that
return 1 on success were left as-is to minimize changes.

Signed-off-by: Ben Warren <biggerbadderben@gmail.com>
Acked-by: Stefan Roese <sr@denx.de>
Acked-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Acked-by: Kim Phillips <kim.phillips@freescale.com>
Acked-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
Acked-By: Timur Tabi <timur@freescale.com>

2 files changed, 6 insertions, 6 deletions

diff --git a/cpu/ixp/npe/npe.c b/cpu/ixp/npe/npe.c
index 7e4af44105..a33b956975 100644
--- a/cpu/ixp/npe/npe.c
+++ b/cpu/ixp/npe/npe.c
@@ -408,25 +408,25 @@ static int npe_init(struct eth_device *dev, bd_t * bis)
 	if (ixEthAccPortRxCallbackRegister(p_npe->eth_id, npe_rx_callback,
 					   (u32)p_npe) != IX_ETH_ACC_SUCCESS) {
 		printf("can't register RX callback!\n");
-		return 0;
+		return -1;
 	}
 
 	if (ixEthAccPortTxDoneCallbackRegister(p_npe->eth_id, npe_tx_callback,
 					       (u32)p_npe) != IX_ETH_ACC_SUCCESS) {
 		printf("can't register TX callback!\n");
-		return 0;
+		return -1;
 	}
 
 	npe_set_mac_address(dev);
 
 	if (ixEthAccPortEnable(p_npe->eth_id) != IX_ETH_ACC_SUCCESS) {
 		printf("can't enable port!\n");
-		return 0;
+		return -1;
 	}
 
 	p_npe->active = 1;
 
-	return 1;
+	return 0;
 }
 
 #if 0 /* test-only: probably have to deal with it when booting linux (for a clean state) */
diff --git a/cpu/mpc8xx/fec.c b/cpu/mpc8xx/fec.c
index da473ca0b1..5a314137d9 100644
--- a/cpu/mpc8xx/fec.c
+++ b/cpu/mpc8xx/fec.c
@@ -727,7 +727,7 @@ static int fec_init (struct eth_device *dev, bd_t * bd)
 
 		if (efis->actual_phy_addr == -1) {
 			printf ("Unable to discover phy!\n");
-			return 0;
+			return -1;
 		}
 #else
 		efis->actual_phy_addr = -1;
@@ -763,7 +763,7 @@ static int fec_init (struct eth_device *dev, bd_t * bd)
 
 	efis->initialized = 1;
 
-	return 1;
+	return 0;
 }