U-Boot does not currently build for PXA platforms with USB support
enabled:

usb.c:46: error: 'UP2OCR' undeclared (first use in this function)

Signed-off-by: Daniel Mack <daniel@caiaq.de>
Cc: Markus Klotzbuecher <mk@denx.de>

Edited commit message.
Signed-off-by: Wolfgang Denk <wd@denx.de>

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>

Signed-off-by: Detlev Zundel <dzu@denx.de>

Add CONFIG_SYS_MONITOR_LEN macro to apollon board config.
CONFIG_SYS_MONITOR_LEN defines the U-Boot image size.
and is used by OneNAND ipl when reading U-Boot image.

Signed-off-by: Rohit Hagargundgi <h.rohit at samsung.com>
Acked-by: Kyungmin Park <kyungmin.park@samsung.com>

The pin which was used in preliminary versions of the board for ide
reset is really connected to the rtc clock.

Signed-off-by: Detlev Zundel <dzu@denx.de>

The BF527-EZKIT settings for storing the environment in SPI flash wasn't
using the correct sector settings for the SPI flash part that is actually
on the board.

Signed-off-by: Mike Frysinger <vapier@gentoo.org>

When dropping jump block support, the assumption was that all bootroms
supported entry point redirection via the EVT1 register.  Unfortunately,
this turned out to be incorrect for the oldest Blackfin parts (BF533-0.2
and older and BF561).  No one really noticed earlier because these parts
usually are booted by bypassing the bootrom entirely, and older BF533
parts are not supported at all (too many anomalies).

Signed-off-by: Mike Frysinger <vapier@gentoo.org>

Signed-off-by: Dirk Behme <dirk.behme@googlemail.com>
Signed-off-by: Manikandan Pillai <mani.pillai@ti.com>

Let CONFIG_SYS_HZ to have value of 1000 effectively fixing all users of
get_timer.

Changes since original version:
* Set PTV=2 (divisor 8) for boards using 12MHz timer clock source to
  improve timer resolution.

Signed-off-by: Ladislav Michl <ladis@linux-mips.org>