u-boot.git/drivers/serial, branch v2011.12

USB: Use (get|put)_unaligned for accessing wMaxPacketSize

2011-12-16T20:37:17+00:00

In 9792987721c7980453fe6447c3fa6593b44f8458 Stefan describes a usecase
where the previous behavior of leaving wMaxPacketSize be unaligned
caused fatal problems.  The initial fix for this problem was incomplete
however as it showed another cases of non-aligned access that previously
worked implicitly.  This switches to making sure that all access of
wMaxPacketSize are done via (get|put)_unaligned.

In order to maintain a level of readability to the code in some cases
we now use a variable for the value of wMaxPacketSize and in others, a
macro.

Cc: Minkyu Kang 
Cc: Remy Bohmer 

OpenRISC:
Tested-by: Stefan Kristiansson 

Beagleboard xM, Pandaboard run-tested, s5p_goni build-tested.
Signed-off-by: Tom Rini

usbtty: init endpoints prior to startup events

2011-12-11T13:42:00+00:00

On some usb device controllers (pxa) the endpoint configuration must be programmed prior to enable it.

Signed-off-by: Stefan Herbrechtsmeier 
CC: Marek Vasut 
CC: Remy Bohmer

tegra2: Remove unused low-level Tegra2 UART code

2011-12-09T16:30:09+00:00

This was used by the AVP in early boot but is no longer used. Unless we
plan to enable it somehow it is not needed. In any case we should try
to use the ns16550 driver instead as it has the same code.

Signed-off-by: Simon Glass 
Signed-off-by: Tom Warren

MX: serial_mxc: cleanup removing nasty #ifdef

2011-12-06T22:59:40+00:00

The serial driver for iMX SOCs is continuosly changed if a
new SOC or not yet used port is used. CONFIG_SYS__
defines were used only to find the base address for the selected UART.
Instead of that, move the base address to the board configuration
file and drop all #ifdef from driver.

Signed-off-by: Stefano Babic 
CC: Marek Vasut 
CC: Wolfgang Denk 
CC: Fabio Estevam 
CC: Helmut Raiger 
CC: John Rigby 
CC: Matthias Weisser 
CC: Jason Liu 
Acked-by: Jason Liu

PXA: Rename CONFIG_PXA2[57]X to CONFIG_CPU_PXA2[57]X

2011-12-06T22:59:32+00:00

Signed-off-by: Marek Vasut

PXA: Cleanup serial_pxa

2011-11-15T21:24:50+00:00

* Cleanup register definitions by introducing new regs-uart.h, compliant with
  rest of U-Boot.
* Remove old register definitions from pxa-regs.h
* Convert serial_pxa to new regs-uart.h
* Cleanup serial_pxa

Signed-off-by: Marek Vasut

sandbox: put stdin into raw mode

2011-11-03T21:35:21+00:00

This allows us to act like a serial device: we get tab chars and CTRL+C
and respond appropriately.

Signed-off-by: Mike Frysinger 
Tested-by: Simon Glass

serial: sandbox: use ssize_t to match os_read

2011-11-03T21:35:16+00:00

Signed-off-by: Mike Frysinger 
Acked-by: Simon Glass

serial: sandbox: optimize puts

2011-11-03T21:35:12+00:00

Signed-off-by: Mike Frysinger 
Acked-by: Simon Glass

ARM:AM33XX: Add support for TI AM335X EVM

2011-10-27T19:56:36+00:00

This patch adds basic support for booting the board.
This patch adds support for the UART necessary to
get to the u-boot prompt.

Signed-off-by: Chandan Nath 
Signed-off-by: Sandeep Paulraj