u-boot.git/drivers/net, branch v2013.01

mv88e61xx: refactor PHY and SWITCH level-code

2013-01-08T22:42:10+00:00

Signed-off-by: Albert ARIBAUD

Merge branch 'u-boot-ti/master' into 'u-boot-arm/master'

2013-01-08T12:15:45+00:00

This required manual merging drivers/mtd/nand/Makefile
and adding am335x_evm support for CONFIG_SPL_NAND_DRIVERS

net: sh_eth: add support for SH7752

2012-12-15T18:28:24+00:00

SH7752 has two fast ethernet controllers and two gigabit ethernet
controllers. It is similar to SH7757.

Signed-off-by: Yoshihiro Shimoda 
Acked-by: Nobuhiro Iwamatsu

phy: Add support for Marvell 88E1118R

2012-12-15T18:28:22+00:00

Marvell 88E1118R has different uid then 88E1118.

Signed-off-by: Michal Simek 
CC: Andy Fleming 
CC: Zang Roy-R61911 
CC: Kumar Gala

e1000e : Correct Rx Threshold granularity

2012-12-15T18:28:21+00:00

In e1000e driver, Rx descriptor queue is used such that hardware can add only
one descriptor at a time. So the WTHRESH granularity in RXDCTL should be set
to single descriptor. This would ensure that every time controller fills a Rx
descriptor, it is flushed to host memory. Earlier this granularity was in
cache line units i.e 2 descriptors. This leads to controller always waiting
for 2 descriptors before flushing them out. But since not more than one Rx BD
is actually available , the accumulation condition never gets hit.

Signed-off-by: Ruchika Gupta 
Signed-off-by: Vakul Garg 
Acked-by: Roy Zang

am335x: cpsw: make phy address configurable

2012-12-10T15:56:38+00:00

Signed-off-by: Yegor Yefremov

powerpc/85xx: add support for the Freescale P5040DS Superhydra reference board

2012-11-28T00:28:06+00:00

The P5040DS reference board (a.k.a "Superhydra") is an enhanced version of
P3041DS/P5020DS ("Hydra") reference board.

Signed-off-by: Timur Tabi 
Signed-off-by: Shaohui Xie 
Signed-off-by: Andy Fleming

drivers/net/: sparse fixes

2012-11-04T18:00:36+00:00

phy.c:46:5: warning: symbol 'genphy_config_advert' was not declared. Should it be static?
phy.c:121:5: warning: symbol 'genphy_setup_forced' was not declared. Should it be static?
phy.c:468:5: warning: symbol 'phy_probe' was not declared. Should it be static?
phy.c:491:19: warning: symbol 'get_phy_driver' was not declared. Should it be static?
phy.c:508:19: warning: symbol 'phy_device_create' was not declared. Should it be static?
phy.c:552:5: warning: symbol 'get_phy_id' was not declared. Should it be static?
phy.c:584:19: warning: symbol 'get_phy_device' was not declared. Should it be sta
vitesse.c:126:5: warning: symbol 'vsc8601_config' was not declared. Should it be static?
vsc7385.c:33:5: warning: symbol 'vsc7385_upload_firmware' was not declared. Should it be static?
tgec_phy.c:33:5: warning: symbol 'tgec_mdio_write' was not declared. Should it be static?
tgec_phy.c:75:5: warning: symbol 'tgec_mdio_read' was not declared. Should it be static?
tgec_phy.c:117:5: warning: symbol 'tgec_mdio_reset' was not declared. Should it be static?
eth.c:48:6: warning: symbol 'dtsec_configure_serdes' was not declared. Should it be static?
p4080.c:26:5: warning: symbol 'port_to_devdisr' was not declared. Should it be static?

Signed-off-by: Kim Phillips

net/: sparse fixes

2012-11-04T18:00:36+00:00

bootp.c:44:14: warning: symbol 'dhcp_state' was not declared. Should it be static?
bootp.c:45:15: warning: symbol 'dhcp_leasetime' was not declared. Should it be static?
bootp.c:46:10: warning: symbol 'NetDHCPServerIP' was not declared. Should it be static?
arp.c:30:17: warning: symbol 'NetArpWaitReplyIP' was not declared. Should it be static?
arp.c:37:16: warning: symbol 'NetArpTxPacket' was not declared. Should it be static?
arp.c:38:17: warning: symbol 'NetArpPacketBuf' was not declared. Should it be static?
atheros.c:33:19: warning: symbol 'AR8021_driver' was not declared. Should it be static?
net.c:183:7: warning: symbol 'PktBuf' was not declared. Should it be static?
net.c:159:21: warning: symbol 'net_state' was not declared. Should it be static?
ping.c:73:6: warning: symbol 'ping_start' was not declared. Should it be static?
ping.c:82:13: warning: symbol 'ping_receive' was not declared. Should it be static?
tftp.c:53:7: warning: symbol 'TftpRRQTimeoutMSecs' was not declared. Should it be static?
tftp.c:54:5: warning: symbol 'TftpRRQTimeoutCountMax' was not declared. Should it be static?
eth.c:125:19: warning: symbol 'eth_current' was not declared. Should it be static?

Note: in the ping.c fix, commit a36b12f95a29647a06b5459198684fc142482020
"net: Move PING out of net.c" mistakenly carried the ifdef CMD_PING
clause from when it was necessary to avoid warnings when it was embedded
in net.c.

Signed-off-by: Kim Phillips

include/linux/byteorder: import latest endian definitions from linux

2012-11-04T18:00:34+00:00

u-boot's byteorder headers did not contain endianness attributions
for use with sparse, causing a lot of false positives.  Import the
kernel's latest definitions, and enable them by including compiler.h
and types.h.  They come with 'const' added for some swab functions, so
fix those up, too:

include/linux/byteorder/big_endian.h:46:2: warning: passing argument 1 of '__swab64p' discards 'const' qualifier from pointer target type [enabled by default]

Also, note: u-boot's historic __BYTE_ORDER definition has been
preserved (for the time being at least).

We also remove ad-hoc barrier() definitions, since we're including
compiler.h in files that hadn't in the past:

macb.c:54:0: warning: "barrier" redefined [enabled by default]

In addition, including compiler.h in byteorder changes the 'noinline'
definition to expand to __attribute__((noinline)).  This fixes
arch/powerpc/lib/bootm.c:

bootm.c:329:16: error: attribute '__attribute__': unknown attribute
bootm.c:329:16: error: expected ')' before '__attribute__'
bootm.c:329:25: error: expected identifier or '(' before ')' token

powerpc sparse builds yield:

include/common.h:356:22: error: marked inline, but without a definition

the unknown-reason inlining without a definition is considered obsolete
given it was part of the 2002 initial commit, and no arm version was
'fixed.'

also fixed:
ydirectenv.h:60:0: warning: "inline" redefined [enabled by default]

and:

Configuring for devconcenter - Board: intip, Options: DEVCONCENTER
make[1]: *** [4xx_ibm_ddr2_autocalib.o] Error 1
make: *** [arch/powerpc/cpu/ppc4xx/libppc4xx.o] Error 2
powerpc-fsl-linux-size: './u-boot': No such file
4xx_ibm_ddr2_autocalib.c: In function 'DQS_autocalibration':
include/asm/ppc4xx-sdram.h:1407:13: sorry, unimplemented: inlining failed in call to 'ppc4xx_ibm_ddr2_register_dump': function body not available
4xx_ibm_ddr2_autocalib.c:1243:32: sorry, unimplemented: called from here

and:

In file included from crc32.c:50:0:
crc32table.h:4:1: warning: implicit declaration of function '___constant_swab32' [-Wimplicit-function-declaration]
crc32table.h:4:1: error: initializer element is not constant
crc32table.h:4:1: error: (near initialization for 'crc32table_le[0]')

Signed-off-by: Kim Phillips 
[trini: Remove '#endif' in include/common.h around setenv portion]
Signed-off-by: Tom Rini