u-boot.git/doc/README.mx28evk, branch master

mx28evk: Move README file inside board directory

2013-06-26T15:40:39+00:00

Board specific READMEs should be located inside the respective board directory.

Signed-off-by: Fabio Estevam

README: mxs: Introduce README.mxs

2013-06-26T15:39:57+00:00

Create a README.mxs file that contains instructions on how to use U-boot for
both MX23 and MX28.

As boot from NAND has only been tested on mx28, make it clear that it only
applies to MX28.

While at it, do some small cleanups for the sake of consistency:
- Use "MX28" instead of "i.MX28"
- Use "section" instead of "chapter" when referring to specific parts of the
reference manual chapters.

Signed-off-by: Fabio Estevam

mx28evk: Introduce a new target for saving env vars to NAND

2013-04-03T08:55:18+00:00

Introduce 'mx28evk_nand' target for saving environment variables into NAND.

The mx28evk board does not come with a NAND flash populated from the
factory. It comes with an empty slot (U23), which allows the insertion of a
48-pin TSOP flash device.

Tested with a K9LBG08U0D.

Signed-off-by: Fabio Estevam 
Reviewed-by: Otavio Salvador

mxs: reorganize source directory for easy sharing of code in i.MXS SoCs

2012-09-01T12:58:17+00:00

Most code can be shared between i.MX23 and i.MX28 as both are from
i.MXS family; this source directory structure makes easy to share code
among them.

Signed-off-by: Otavio Salvador 
Acked-by: Stefano Babic

mx28evk: Fix PSWITCH key position

2012-07-07T12:07:29+00:00

Fix the position for PSWITCH key.

The good benefit of doing this is that boot time is greatly reduced:
from 5 seconds to less then 1 second.

Signed-off-by: Fabio Estevam 
Acked-by: Marek Vasut

mx28evk: Add a README file

2012-04-16T12:53:58+00:00

Add a README file for mx28evk board.

Signed-off-by: Fabio Estevam 
Acked-by: Marek Vasut