summaryrefslogtreecommitdiffstats
path: root/Documentation/networking/framerelay.txt
diff options
context:
space:
mode:
Diffstat (limited to 'Documentation/networking/framerelay.txt')
-rw-r--r--Documentation/networking/framerelay.txt39
1 files changed, 0 insertions, 39 deletions
diff --git a/Documentation/networking/framerelay.txt b/Documentation/networking/framerelay.txt
deleted file mode 100644
index 1a0b720..0000000
--- a/Documentation/networking/framerelay.txt
+++ /dev/null
@@ -1,39 +0,0 @@
-Frame Relay (FR) support for linux is built into a two tiered system of device
-drivers. The upper layer implements RFC1490 FR specification, and uses the
-Data Link Connection Identifier (DLCI) as its hardware address. Usually these
-are assigned by your network supplier, they give you the number/numbers of
-the Virtual Connections (VC) assigned to you.
-
-Each DLCI is a point-to-point link between your machine and a remote one.
-As such, a separate device is needed to accommodate the routing. Within the
-net-tools archives is 'dlcicfg'. This program will communicate with the
-base "DLCI" device, and create new net devices named 'dlci00', 'dlci01'...
-The configuration script will ask you how many DLCIs you need, as well as
-how many DLCIs you want to assign to each Frame Relay Access Device (FRAD).
-
-The DLCI uses a number of function calls to communicate with the FRAD, all
-of which are stored in the FRAD's private data area. assoc/deassoc,
-activate/deactivate and dlci_config. The DLCI supplies a receive function
-to the FRAD to accept incoming packets.
-
-With this initial offering, only 1 FRAD driver is available. With many thanks
-to Sangoma Technologies, David Mandelstam & Gene Kozin, the S502A, S502E &
-S508 are supported. This driver is currently set up for only FR, but as
-Sangoma makes more firmware modules available, it can be updated to provide
-them as well.
-
-Configuration of the FRAD makes use of another net-tools program, 'fradcfg'.
-This program makes use of a configuration file (which dlcicfg can also read)
-to specify the types of boards to be configured as FRADs, as well as perform
-any board specific configuration. The Sangoma module of fradcfg loads the
-FR firmware into the card, sets the irq/port/memory information, and provides
-an initial configuration.
-
-Additional FRAD device drivers can be added as hardware is available.
-
-At this time, the dlcicfg and fradcfg programs have not been incorporated into
-the net-tools distribution. They can be found at ftp.invlogic.com, in
-/pub/linux. Note that with OS/2 FTPD, you end up in /pub by default, so just
-use 'cd linux'. v0.10 is for use on pre-2.0.3 and earlier, v0.15 is for
-pre-2.0.4 and later.
-