summaryrefslogtreecommitdiffstats
path: root/Documentation/hwmon/sht21
diff options
context:
space:
mode:
Diffstat (limited to 'Documentation/hwmon/sht21')
-rw-r--r--Documentation/hwmon/sht2149
1 files changed, 0 insertions, 49 deletions
diff --git a/Documentation/hwmon/sht21 b/Documentation/hwmon/sht21
deleted file mode 100644
index db17fda..0000000
--- a/Documentation/hwmon/sht21
+++ /dev/null
@@ -1,49 +0,0 @@
-Kernel driver sht21
-===================
-
-Supported chips:
- * Sensirion SHT21
- Prefix: 'sht21'
- Addresses scanned: none
- Datasheet: Publicly available at the Sensirion website
- http://www.sensirion.com/en/pdf/product_information/Datasheet-humidity-sensor-SHT21.pdf
-
- * Sensirion SHT25
- Prefix: 'sht21'
- Addresses scanned: none
- Datasheet: Publicly available at the Sensirion website
- http://www.sensirion.com/en/pdf/product_information/Datasheet-humidity-sensor-SHT25.pdf
-
-Author:
- Urs Fleisch <urs.fleisch@sensirion.com>
-
-Description
------------
-
-The SHT21 and SHT25 are humidity and temperature sensors in a DFN package of
-only 3 x 3 mm footprint and 1.1 mm height. The difference between the two
-devices is the higher level of precision of the SHT25 (1.8% relative humidity,
-0.2 degree Celsius) compared with the SHT21 (2.0% relative humidity,
-0.3 degree Celsius).
-
-The devices communicate with the I2C protocol. All sensors are set to the same
-I2C address 0x40, so an entry with I2C_BOARD_INFO("sht21", 0x40) can be used
-in the board setup code.
-
-sysfs-Interface
----------------
-
-temp1_input - temperature input
-humidity1_input - humidity input
-
-Notes
------
-
-The driver uses the default resolution settings of 12 bit for humidity and 14
-bit for temperature, which results in typical measurement times of 22 ms for
-humidity and 66 ms for temperature. To keep self heating below 0.1 degree
-Celsius, the device should not be active for more than 10% of the time,
-e.g. maximum two measurements per second at the given resolution.
-
-Different resolutions, the on-chip heater, using the CRC checksum and reading
-the serial number are not supported yet.